Logo
FULL SITE MENU

Search results

  1. P

    Tohatsu Remote Control Throttle design/ adjustment/ wear/ maintenance ?

    I have a 1991 M30A3 with remote throttle and the remote control lever will take and hold a full throttle condition until the boat speeds up and gets on plane and then when I throttle back to something like 4800 or 5000 rpms for permanent cruising the rpms will bleed off slowly over the next...
  2. P

    Fuel Filter embarrassment with M30A3

    There is a little fuel bowl under the engine cover of the Tohatsu M30A3 and the one I recently bought did not contain any kind of filter in it..... So I ordered one from Tohatsu USA and what I got in an envelope was a little zip lock big enough to hold a car key and it also had a piece of...
  3. P

    Best filter product best deal for outboards

    I was looking around for some recommended fuel filters for my newly acquired boat and found this Honda Labeled (Racor made) fuel filter that was 30/40 dollars cheaper than elsewhere and even cheaper than when sold as the Racor brand at the same website. What I really wanted was an easy to...
  4. P

    Are Anodes needed for fresh water only immersion ?

    I just bought a 1991 year old Tohatsu 30hp that was winter prepped and stored in barn for 15 years. It looks and runs good now but in the location where the anode is supposed to be there is nothing. I expect the boat will see contact with fresh inland water only about 125 hours a year and...
  5. P

    Fuel Filter suggestions for 30hp M30A3

    I was cleaning out the thimble sized fuel bowl next to the carb which someone had forgotten to put a filter in and didnt even realize it was supposed to have a filter till I saw it in the service manual. In any case I was planning on putting a good low restriction and fine micron that is...
  6. P

    1st boat in 63 years powered by 30hp M30A3 probably made in 1991

    I didnt know enough to ask how old the motor was but the boat and motor cranked immediately and ran perfectly and was in outstanding condition so I probably paid too much. I am now learning that the age of a motor makes a difference and there may be some vital parts to keep it running that...
  7. P

    Suggestions for design of Inboard setup for Kohler 25hp VTwin

    I am seeking almost any kind of 11 or 12 ft long hull to install a 25HP Kohler VTwin into via the use of an inboard prop shaft etc. What I am effectively wanting is a cheaper to run ( and acquire) substitute for a Personal Watercraft. I am strongly influenced by the Racing Crab Skiffs up...
Back
Top