Logo
FULL SITE MENU

Search results

  1. B

    1972 Evinrude 125 HP PROBLEM ID Verification Please

    Problem: Bought boat 1 month ago. Has never ran right. Runs good cold or warm but after 10 to 30 minutes at WOT slowly gives up speed, runs rough and won't allow over 2,000 RPM's. Idles nice and trolls good, does not stall. Has done this 9 times during trial runs. Today only ran 10 minutes...
  2. B

    1972 Evinrude 125 HP ROTOR AND SENSOR GAP PIC ATTACHED

    I believe this is a phase II rotor and the correct one for this motor. I have 2 CDI instructions for pulse pack 113-8362. One says phase II for 1968-1971. The other just says for Prestolite battery ignitions with pick up require phase II rotor. Other problem: See where the sensor is and how...
  3. B

    1972 Evinrude 125 HP stator and rectifier question

    My motor is running fine for 30 minutes then misses badly. Only can get 2200 RPM's. Next day same problem, runs good for 30 minutes then misses badly. Did some more trouble shooting and can someone please verify this with me? Did an ohm's test on the rectifier and everything checked out except...
  4. B

    1972 Evinrude 125 HP S.L.O.W. FEATURES

    Doing some more research on my motor running rough after several WOT runs. DO I have the slow feature on my motor? I have the 113-8362 pulse pack. I runs good for 30 minutes then boggs down and won't let me run over 2500 RPM's. It has done this now on 8 test runs. Sounds like the slow feature...
  5. B

    1972 Evinrude 125HP TEST #8 SAME PROBLEM HELP

    Went for another test drive after moving the choke solenoid wire. It did run better. I went for a 30 minutes WOT throttle run with changes in speed. Ran Great. Then ran at trolling speed for awhile and when I sent back to WOT the motor started to miss. So bad that I limped back to the launch at...
  6. B

    1972 Evinrude 125 HP Model 125283 UPDATE

    Tested overheating horn. It works. Moved the choke solenoid wire. Another test drive. Seems to have solved the problem. Took it for a run and it didn't skip but didn't quite finish the testing. It was pretty windy out on the water. She would only go 5100 RPM's and 30 MPH. Last time she would...
  7. B

    1972 125 Evinrude electrical issue?

    Had this boat for 3 weeks now and I have the same problem. The boat will go WOT at first about 5 to 10 minutes then slowly lose power until your trolling. Did all the checks, compression is good. Pulse pack checks out. Wiring seems right. At first I thought it was a fuel issue and I rebuilt...
  8. B

    1972 125 HP Model 125283 no start/ clipper module question

    Just bought boat and had it out on water. Ran good for 10 minutes then had only half throttle before in would just bogg down. Fix this problem with a carb clean and fuel pump. Also had to put on a new starter. Replaced the water impeller as well. Had it back out on water WOT and it ran good...
Back
Top