Logo
FULL SITE MENU

Search results

  1. J

    Disconnecting shift shaft 1997 50 hp yamaha

    i am trying to remove my lower i am trying to remove my lower unit and cannot figure out how to drop the lower unit. there is a arm connected to the shift shaft with a pin through it and i have removed the pin but the gearcase wont drop. thanks in advance
  2. J

    2000 8hp 2 stroke yamaha tiller motor starts then stalls

    "hi and thanks in advance my "hi and thanks in advance my 8hp yamaha will start and run but then it will stall. i pump the ball back up and it will do the same i cleaned the carb twice just to make sure it wasnt that. installed new diaphrams in the fuel pump changed the plugs and the fuel...
  3. J

    150 MERC 1989 HARD TO START

    "this is a new one on me my mo "this is a new one on me my motor is really hard to turn over even with the plugs out. the starter is struggling to start the motor it will start and then die at idle i can rev it and keep it running but low rpm wont stay running compression is 125 on each...
  4. J

    175 ocean pro question

    i have a 175 ocean pro it has i have a 175 ocean pro it has a plastic tag on it but its sun bleached cant read year however my question is is that motor direct injection ? it has 6 carbs and it appears to have injection rails. are there any inherant problems with these motors ? thanks...
  5. J

    Shocking experience

    "i have a 175 evinrude mid 80s "i have a 175 evinrude mid 80s and i get shocked when i touch the control box. i just started the motor in the dark to see if i could find an arc somewhere and found nothing,went through the wiring everything is hooked up right removed all grounds cleaned and...
  6. J

    HELP removing lower unit on 30 hp evinrude 1989

    i have dropped all bolts and d i have dropped all bolts and disconnected the shift shaft gear case will only drop about a 1/4 of a inch. am i missing somthing ? i have looked the motor over to see any other connections but found none it doesnt have an anoid on the bottom with a consealed...
  7. J

    2003 115 suzuki corrosion

    i was told these motors have c i was told these motors have corrosion issues does anyone know this to be a fact?
  8. J

    2003 115 suzuki

    i was told these motors have c i was told these motors have corrosion issues does anyone know this to be a fact?
  9. J

    Oil leak 1999 99 4 stroke leaking crank case oil out of lower unit

    1999 4 stroke 9.9 that runs pe 1999 4 stroke 9.9 that runs perfect if i leave it set after i run it crankcase oil leaks out of the lower unit. its definitly not gear lube HELP
  10. J

    Changing shifter on 2001 20 hp johnson

    i have a 01 20 hp johnson the i have a 01 20 hp johnson the motor was dropped and the shifter and the shaft were broken off does anyone know if i need to pull the power head to fix it? also that same motor has a removeable section on the mid section that is 5 inches tall if i remove it and...
  11. J

    Riser plugs

    I am installing new risers on I am installing new risers on my 350 inboard. The directions I got with the risers said I should not use teflon products on any of the fittings. What should I coat the plugs with?
Back
Top