Logo
FULL SITE MENU

Search results

  1. J

    Rubbing noise under flywheel 94 Merc 115 4cyl

    " I just took my boat with 94 " I just took my boat with 94 Merc 115 4cyl in to get the timing and carbs adjusted. They said there is a rubbing noise coming from under the flywheel. I have heard this before, but I think it goes away when in gear.(not positive) They said $100-$150 to pull the...
  2. J

    94 Merc 115

    " I have a 94 Merc 115. It&#39 " I have a 94 Merc 115. It's a 4 cyl and I think it is the 2+2 system. I am getting a slight surge when in forward gear at closed throttle. If I give it a little more gas, the surge stops. Is this normal for the 2+2 system, or is it something I should be...
  3. J

    Help on Gasket Maker type

    " Hi. What is the recommended " Hi. What is the recommended gasket maker for sealing a Honda 2hp 4-stroke crankcase/block? Thanks, james "
  4. J

    94 Merc 115 Oil Sensor

    Does anyone know how to test Does anyone know how to test the oil sensor on a 94 Merc 115. I drained all the oil out of the tank and took the sensor out and no alarm. Is there a way to tell if it is a bad sensor or a bad warning module. I tested the temp sensor by grounding against the block...
  5. J

    94 Mercury Warning Buzzer

    " I have a 94 Merc 115, bought " I have a 94 Merc 115, bought last fall and haven't had in the water yet. Noticed no alarm sound when I turned the key to run. Checked under the dash and the buzzer had one wire connected to the ignition, and the other purple wire had been cut. But... there were...
  6. J

    Mercury Power TrimTilt

    " I own a Mercury 850 with pow " I own a Mercury 850 with power trim/tilt. Inoticed the hydraulic fluid was low. What kind of fluid would be best suited for this? Would standard ATF work, or is there some special fluid for the trim/tilt? "
  7. J

    50 hp mercury water pump

    " Can anyone tell me how much " Can anyone tell me how much water should be coming out of the tattle tale hole on the above motor. It is spitting water, but I am use to seeing a nice stream coming out. I just purchased the motor and the old owner told me it has always looked like that. Has...
  8. J

    Evinrude SkiTwin spark plug gap

    I have a 33hp Evinrude Ski-Tw I have a 33hp Evinrude Ski-Twin. And I would like to how wide to gap the plugs. If anyone could tell me it would be a great help. Thank You James
  9. J

    Need Carb Kit for 30hp Johnson RD18

    "Anyone have a Carb Kit for a "Anyone have a Carb Kit for a 56 30hp Johnson? And how much would you want for it. Please email me at [email protected] Thanks"
  10. J

    Do i need a new power pack

    " i have a old 76 model johnso " i have a old 76 model johnson that was sitting up for a year,i got it started but when i tried to give it gas it stalls out, everyone i ask about it was sure it was the carburetor ,but when i took it to the shop they told me it wasn't firing on all...
  11. J

    Outboard hp and year

    serial number 68600712-1533 serial number 68600712-1533 model number 574-59932 thanks for any help
  12. J

    Outboard hp and year

    serial number 68600712-1533 serial number 68600712-1533 model number 574-59932 thanks for any help
  13. J

    What kind of spark plugs do I need for volvo AQ151C

    " The repair man left with the " The repair man left with the plugs and never came back. I am trying to find out what kind I need and put them in myself. This is difficult because it is a 1988 and all the parts stores that are open just want to match plugs that I bring in, which I can't do "
  14. J

    Volvo 290 trim problems

    " We just replaced the hydraul " We just replaced the hydraulic hoses on our Volvo Penta 290 drive. We bled the system and the drive now moves up and down without a problem. We left the drive up over night and it did not drop. When the drive is in the down locked position, we can rise it with...
  15. J

    ATTN TONYOB mercury 60hp cylinder bore specs

    " Hi Tony, I noticed you " Hi Tony, I noticed your the guy to ask about mercs. I have a 1999 mercury 60hp (965cc) bigfoot which requires an oversized piston. Can you help with with the bore specifications as well as ring end gap specs? Thanks and more power! James "
  16. J

    HELP JOHNSON 225HP SHIFT INTERRUPTER SWITCH

    " I have a problem with a John " I have a problem with a Johnson 225hp shift interrupter switch which suppose to momentarily kill one bank to lower rpm to facilitate forward or reverse gear shifting. The shift switch itself is good since rpm drops when its pin is manually depressed. However no...
  17. J

    GEARCASE CHANGE OIL IN WATER

    Is there a way to change gear Is there a way to change gearcase oil with boat in water other than pulling off its gearcase? Thanks in advance.
  18. J

    Petter W1 Series Engine

    " Hi, I'm looking for a " Hi, I'm looking for an alternator (new/used) for a Petter W1 series engines. Any ideas where to find one??? "
  19. J

    More help on a 1971 Johnson 60 HP

    " I had posted before that I n " I had posted before that I needed a new forward, reverse gears, and a clutch dog for this motor(I also had him ship me the prop shaft from the motor the parts were coming from). I found one used and had it shipped to me. I also ordered one of the service manual...
  20. J

    JOE BIG PROBLEM FROM SMALL OBM

    " Hi Joe, Thanks for your r " Hi Joe, Thanks for your response to my post re detonation of 115HP. Will check set timing as you suggested. I have a Mercury 4HP 1996. WOT specs is 4500-5500rpm but could squeeze out only 3700. Compression is 115psi and spark can jump 3/8 gap on tester...
Back
Top