Logo
FULL SITE MENU

Search results

  1. A

    Evinrude 2000 200HP Trim Tilt operation

    "I just repowered my boat and "I just repowered my boat and I am having trouble with the # 7 fuse in the EMM. It blows everytime I activate the Trim Tilt switch, remotely or on the engine. I have completed the tests as defined in the service manual and all voltage readings check as OK. Any...
  2. A

    Am I overheating 4hp Johnson

    "I'm new to outboards and "I'm new to outboards and fear my 4hp 1981 Johnson is getting too hot. I've checked the impeller and it's fine. I'm getting a small amount of warm water out of the tell tale hole's down the shaft, not a lot. I understand the majority of pumped water exits with the...
  3. A

    Can anyone help me here please

    " looking for what compresasio " looking for what compresasion should be on 25 hp Yamaha. Engine will not idle, suspect not enough compression to advance timing at idle "
  4. A

    Compression on 25hp Yamaha

    " bought used outboard, did no " bought used outboard, did not idle, tought it was just carb adjustment but after looking at it closer noticed at idle the vaccum advance on the timing not working, suspect engine not creating enough compression at idle to advance timing, how much should it be? "
  5. A

    Online manual for 1987 Suzuki 25hp

    im fixing up a 1987 suzuki 25 im fixing up a 1987 suzuki 25hp motor and i was wondering if there is an online manual for it some where? or if someone knew where a good place to look would be?
  6. A

    Suzuki dt4 runs good but doesnbt go into gear

    " I just picked up a Suzuki dt " I just picked up a Suzuki dt4, don't know the year exactly. I put it in the water, cranks fine. Shifted into forward, and run for a few minutes. Killed motor, and now, will still crank but not shift to forward or reverse. This was my first time to use motor...
  7. A

    Upgrading ignition on 454

    " I have 1976 Mercury 454' " I have 1976 Mercury 454's with Thunderbolt electronic ignition. All of the parts for the ignition have gone obsolete, and I'm thinking about ripping the whole ignition off and starting from new. Does anyone know of a resource that can/will advise on what current...
  8. A

    Need Tach for Merc Thunderbolt I

    " I have 1976 Merc 454's w " I have 1976 Merc 454's with what is apparently Mercury's earliest Thunderbolt ignition package. The tachometers are non-standard: They only have two terminals, one going to the "tach" terminal on the ignition, and the other to ground. The tach pin is labelled...
  9. A

    Rebuild or Replace 1976 Merc 454bs

    " I bought a 1976 Bertram 35 t " I bought a 1976 Bertram 35 this year that has original Mercruiser 350HP 454's with about 1100 hours each, fresh water operation only. Both engines start and run smoothly, with minimal smoke and only a little oil slick seen after idling for several minutes...
  10. A

    ServiceCheckLube for just purchased older outboards

    " Does anyone have a list of m " Does anyone have a list of must-replace or must-do items before using an older outboard just purchased (ie. plugs, wires, lower unit oil,water pump impeller, etc.)? In this case, a well maintained 85 hp Johnson, and 15 hp Johnson kicker, both '79s. "
  11. A

    Archive through July 31 2000

    " I'm considering buying a " I'm considering buying a boat with this engine on it. It looks clean, and the entire rig is well maintained. Does anyone know anything good or bad about this model? Any trouble spots to look for? I'll be test driving it next weekend, but am a bit leary about a...
Back
Top