Logo
FULL SITE MENU

Search results

  1. F

    Carburetor linkage on a 3.0

    Does anyone have a picture of the carburetor linkage that is near the exhaust riser (2 piece)? I didn't take any pics before I replaced the head and I don't remember how that cable attached to the exhaust manifold shoulder bolt.
  2. F

    Alpha 1 Gen1 sliding clutch

    I have the lower unit off, and checking the shift shaft. Should the sliding clutch 'snap' into place as you turn the shift shaft into gear? I've watched videos from others that when the turn the shift shaft, it seems to click into place. On mine, I turn it until it stops for forward gear, I...
  3. F

    Exhaust valve seat- Mercruiser 3.0

    Had a bad exhuast valve on #1 cylinder, and have a replacement valve ready to go in. When I drop the valve into the seat, it is probably .020 deeper than the other 3 exhaust valves. Springs are removed, valves measures the same as the original one. Is it possible the seat took a deeper set? The...
  4. F

    Where should I cut for motor mount

    I'm working on a 1985 Rinker v170 with mercruiser 3.0 and have an issue with the front 2 lag bolts are rusted and not biting into anything solid. I need to cut into the motor mount platform, but not sure where. Here is a pic of what my plan to do unless I am told otherwise by someone who knows...
  5. F

    Mercruiser 3.0 Intake/Exhaust manifold warped

    Call me an idiot, but when trying to remove my manifold, I thought it was stuck due to rust, but I didn't see one bolt the I neglected to remove. As a result, I warped the manifold and now it doesn't fit flush with the head. There is a .016 gap now where I was trying to wedge it off. Is there a...
  6. F

    OMC Shift/throttle cables to gen1

    My boat is currently setup for OMC controls to the old Evinrude, and I have just replaces it with a Mercury Thunderbolt 50HP. I have the Mercury control box, but I want to use the original control cables. Does someone know if there is a cable end adapter that will adapt the omc style cable ends...
  7. F

    60652 not starting

    I have a 1966 60hp Evinrude that won't start. the first issue is it seems as though I am not getting fuel to the cylinders. The bowl is full after pumping the primer bulb, removed and cleaned the main jets, removed and cleaned the idle needles, carb rebuild, checked the reed plates. Spark in...
  8. F

    60652 Sportfour Extension housing hole

    Why is there a hole in the extension housing? Should it be sealed? The pic below isn't mine, but it looks similar
Back
Top