Logo

Search:

Type: Posts; User: Boobie

Page 1 of 4 1 2 3 4

Search: Search took 0.03 seconds.

  1. Re: 1987 225 johnson tach jumps around at idle

    Check your charging system.
  2. Replies
    11
    Views
    74

    Re: sparks per revolution

    Try a 13x15.
  3. Re: Johnson/Evinrude 8hp J8REUC Fuel Consumption

    An older outboard will use 10 % of horsepower in fuel consumption at wide open throttle in gal per hour. Figure it out for yours ??
  4. Re: 1989 25HP Johnson Tracker Ran great suddenly stopped

    First thing check your compression. Then check your spark. Should jump a 5/16" open air gap on a spark tester.
  5. Re: 2002 Johnson 50hp outboard - died while in water

    Post the model # ?????
  6. Replies
    3
    Views
    71

    Re: Johnson 25 1999 carb.

    Clean the carb...
  7. Re: '92 Johnson 120HP won't start consistently

    Better start looking into your ignition system. Go to CDI Electronics .com for trouble shooting.
  8. Replies
    6
    Views
    91

    Re: 3cyl 60hp Johnson bogging down

    What's the compression on it ?? Will the spark jump a 7/16" open air gap on a spark tester ??
  9. Replies
    6
    Views
    155

    Re: Small problem 9.9 Evinrude

    Edit.....
  10. Replies
    3
    Views
    99

    Re: J48ESLEDC wiring

    Find an OMC service manual for that motor and there's a wiring diagram for it in them.
  11. Replies
    11
    Views
    239

    Re: 1968 johnson 9.5hp issues

    Well, what happened ??
  12. Replies
    9
    Views
    132

    Re: Motor stalls when in gear

    Check spark. Should jump a open 7/16" air gap on a spark tester.
  13. Replies
    1
    Views
    68

    Re: Trim sending unit question?

    The green wiring is for down. Check that again.
  14. Replies
    3
    Views
    161

    Re: Problem 4hp Johnson outboard

    Check the compression and the spark which should jump a 1/4 ' open air gap on a spark tester.
  15. Replies
    11
    Views
    239

    Re: 1968 johnson 9.5hp issues

    That compression seems on the low side. Take a good insulated handle screw driver, stick it in the plug wire and hold it 1/4" away from the block and crank the mtr over. If spark is good it will jump...
  16. Replies
    11
    Views
    239

    Re: 1968 johnson 9.5hp issues

    What's the compression on it ?? Will the spark jump a 1/4" open air gap on a spark tester ??
  17. Replies
    3
    Views
    115

    Re: ethonal free gas

    Same thing in south west FL.
  18. Replies
    7
    Views
    106

    Re: 1976 25hp won't go past 1700 rpm

    Do a cylinder drop test on it to see which cylinder isn't firing and go from there.
  19. Replies
    1
    Views
    66

    Re: Temperature Gauge

    Edit...…..
  20. Replies
    4
    Views
    73

    Re: Keyed ignition power

    Yes…..
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4