Logo

Search:

Type: Posts; User: vics

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    4
    Views
    69

    Re: Really Strange Spark Plug Issues!!

    You dont say what engine or what plugs you are using.
    However you have started 6 or 7 threads in the last 3 months about a 1982 Evinrude 60 HP presumably that's the one (E60TLCNM)?

    The...
  2. Replies
    8
    Views
    103

    Re: Johnson 1998 5hp problem after rebuild,help

    I think you probably mean J5RLECS. ITYWF that it is a rebadged Suzuki
  3. Replies
    1
    Views
    58

    Re: Evinrude ignition switch

    By cutting off the push on connector for the spade terminal and fitting a ring terminal of the correct size perhaps ?
    (use an insulated type or cover the crimp with heat shrink sleeve)
  4. Thread: Starting Issues

    by vics
    Replies
    7
    Views
    94

    Re: Starting Issues

    Battery state of charge too low ?

    Battery defunct?

    Bad electrical connection ?

    Clean and remake all the main battery wiring connections , not forgetting the negative.

    Recharge the battery...
  5. Replies
    11
    Views
    112

    Re: 1988 15 hp johnson shifting issue

    This all sound s perfectly normal.

    You should not be trying to engage either forward or reverse if the engine is not running. My owners manual make that perfectly clear.


    If it is necessary...
  6. Replies
    11
    Views
    112

    Re: 1988 15 hp johnson shifting issue

    Finding a spot where you cannot engage gear when the engine is not running is normal. It's a characteristic of the dog clutch. You might find a point where it wont engage forward, or where it wont...
  7. Thread: Shift shaft .

    by vics
    Replies
    14
    Views
    120

    Re: Shift shaft .

    's right

    According to the Seloc manual on the Boatinfo website 1992 to 1996, 60, V4 and V6 motors , extra longshaft: 26", (with an acceptable range of 1/32")
  8. Replies
    11
    Views
    112

    Re: 1988 15 hp johnson shifting issue

    So you are saying that it wont engage forward when the engine is running but, provided you turn the flywheel a bit, you can put it in gear and then start it ?


    Electric start or rope start ?
  9. Replies
    11
    Views
    112

    Re: 1988 15 hp johnson shifting issue

    I dont understand

    If the motor is running the flywheel will be spinning

    If the motor is not running then it might not engage gear because the dog clutch might not allow it

    My owners manual...
  10. Replies
    3
    Views
    97

    Re: 2H Johnson motor won't fire

    You say the spark is good, but how good ? will it jump a 1/4" ?

    If the spark is good it ought to at least fire briefly if starting fluid or fuel mix is sprayed into the intake

    Have you tried a...
  11. Replies
    9
    Views
    122

    Re: Johnson 6.0 hp J6REOD mystery wires

    Yes I know.... I have an earlier Evinrude version, a 6 hp Yachtwin. You dont run the outboard much on a sailing boat so a dead loss when it came to keeping the battery charged.

    A 5 watt solar...
  12. Replies
    9
    Views
    122

    Re: Johnson 6.0 hp J6REOD mystery wires

    AC lighting usually terminates with a socket on the lower cowl

    When there is a cable like you describe, color coded red and black, it is a DC output, from a rectifier, for battery charging
    ...
  13. Thread: J48ESLEDC wiring

    by vics
    Replies
    3
    Views
    111

    Re: J48ESLEDC wiring

    Perhaps what you need is the printed original manufacturers manual.

    You can buy them from Outboard books

    https://www.outboardbooks.com/manual/J48ESLED/Johnson/
  14. Replies
    11
    Views
    149

    Re: 1975 Johnson 50ESL 75B electrical readings

    Read on-line or download PDF here http://www.marineengine.com/parts/cdi-electronics-outboard-parts/


    You will need a "peak reading" meter or a DVA adapter.. The latter is simple enough to make
  15. Replies
    4
    Views
    147

    Re: how to test a tach.

    But be aware that some replacement rectifier/ regulators do not have a purple wire.
  16. Replies
    6
    Views
    82

    Re: 1987 E40ELCUD rectifier wiring diagram

    Be aware that the replacement rectifier may have 3 plain yellow wires ( there is no need to distinguish between them)which connect to the yellow, yellow/blue and Yellow gray wires coming from the...
  17. Replies
    4
    Views
    147

    Re: 1990 Johnson 4hp, carb not drawing in fuel.

    When you say "pin" you are referring to the float needle valve? Part of #12 in the diagram below

    If so make sure it is fitted pointed end into the seat and that it is clipped to the float arm with...
  18. Re: 1981 Johnson J10RCID 9.9hp Outboard Motor Slips Out of Forward

    Or if it is genuinely jumping out of gear into neutral such that you have to re-engage gear or hold it in gear manually it is likely to be a worn dog clutch.

    Over time, especially if gear is...
  19. Replies
    1
    Views
    90

    Re: 2004 Johnson 6hp fuel pump rebuild kit

    Pin ??

    2 stroke or 4 stroke? ........ always quote the model number when asking questions ( or ordering parts )
  20. Re: 1997 Johnson 115hp 2 cycle transom swivel bracket anode location

    In which case it is the single bar type anode ........... you can see it in the parts diagram on this site

    Or see it on my attached diagram ( I hope the red arrows point to where it fits )

    23712
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4