Logo

Search:

Type: Posts; User: mcomm

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Re: Are all single engine setups standard rotation?

    Read the original question23129
  2. Replies
    5
    Views
    1,981

    Re: Question on 350 sbc omc 800 build

    256 degree cam
  3. Replies
    4
    Views
    1,504

    Re: carbrated 5.7 mercuriser alpha 1 drive

    Check flyweights in distributor for freeness
  4. Replies
    2
    Views
    2,316

    Re: Raw water pump corrosion

    We like pictures
  5. Thread: temp gauge

    by mcomm
    Replies
    9
    Views
    1,601

    Re: temp gauge

    Old thread 2011 rectified years ago
  6. Replies
    33
    Views
    3,994

    Re: 318 reverse rotation already assembled

    This string started 2013!!!! Old news
  7. Replies
    38
    Views
    4,559

    Re: 318 rebuild advice

    Many engine builders install directional pistons to make more horsepower. The offset increases drag. Also many pistons have no offset at all.
  8. Replies
    11
    Views
    968

    Re: Sierra electronic distributor for 318

    Standard Chrysler electronic works for me.
  9. Re: Are all single engine setups standard rotation?

    To answer the question NO there is always the exception
  10. Replies
    5
    Views
    210

    Re: 5.0 MPI Intake Manifold

    Remove spark plugs, remove TB, shop vac while rotating crank to open different intake valves.
  11. Re: questions again.... 181ci 4cyl timing problem....

    Yup, good old Ray and Tom. They were lifters, not followers.
  12. Re: GM Hydraulic lifter preload adjustment question

    My preference is to drain the lifters and set the valve stem clearances to .050-.060 using the one cylinder at a time method. BTW that is for LA engines. For SBC I'd go one full turn.

    Mechanical...
  13. Re: questions again.... 181ci 4cyl timing problem....

    So, after all the RMBS, what did you work out for the distributor advance?
  14. Re: shift interrupter connection to dist wire???

    From what you described that would be my choice.
  15. Re: GM Hydraulic lifter preload adjustment question

    Nothing
  16. Re: GM Hydraulic lifter preload adjustment question

    Too many beer stops bad for diet er.

    Where is top of base circle?

    http://www.marineengine.com/boat-forum/attachment.php?attachmentid=22927&d=1585134720&thumb=1Right on Jack.
  17. Replies
    4
    Views
    432

    Re: 1987 Bayliner 29 small block Chevy

    Of course you are.
  18. Replies
    4
    Views
    432

    Re: 1987 Bayliner 29 small block Chevy

    This refers to a 29'er, the other is 28'er.
  19. Replies
    23
    Views
    972

    Re: Merc 305 to Volvo 350 swap

    Nice gibbet.
  20. Replies
    119
    Views
    4,150

    Re: New 3.0 in older boat

    aka tappets
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4