Logo

Search:

Type: Posts; User: iang6766

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Re: 2004 Honda 150, side UP/DOWN switch doesn't work

    The switch needs to be disconnected for cowl removal during service, it may not have been reconnected at last service. Check and see that the plug is connected. These switches can also stick and for...
  2. Re: Honda BF90D 2007 won't reving up 4000 rpms.

    Might pay to have injectors serviced too. Are you sure the motor isn't just badly over propped or too small for the boat you put it on?
  3. Re: BF135 Overheating Alarm and Control Panel Question

    As mentioned above, start with grommets at waterpump and tube into the mid section.You mentioned water pressure at 6psi, if this is at mid rpm it's way too low, should be at least 20psi.
  4. Re: BF135 Overheating Alarm and Control Panel Question

    Is this boat by any chance in PNG?
  5. Replies
    14
    Views
    358

    Re: Starboard BF200 High Fuel Consumption

    Good result here.Just a comment, O2 sensors can be out of range and fail to throw a code if sending a signal. This is where DrH takes the guess work out of issues since you can monitor the sensor...
  6. Replies
    4
    Views
    176

    Re: Honda BF60A intermittent rough idle

    Happy to be of assistance
  7. Replies
    4
    Views
    141

    Re: 1999 BF90AX drive shaft seal direction

    All the Jap motors have their seals facing out but I install back to back because it works better, they hold pressure better that way, just sharing my experience.
  8. Replies
    4
    Views
    141

    Re: 1999 BF90AX drive shaft seal direction

    Seals back to back,ie bottom seal spring toward gear oil, top seal spring towards waterpump
  9. Replies
    3
    Views
    172

    Re: 2001 Honda stutter when cold

    A good carb clean out should do the trick
  10. Replies
    3
    Views
    172

    Re: 2001 Honda stutter when cold

    What engine?
  11. Replies
    4
    Views
    176

    Re: Honda BF60A intermittent rough idle

    The only thing that can cause that is a lazy idle air control valve (IAC) which could be cause by a blocked filter screen. Remove the IAC and check the fine screen on the intake, they can get pretty...
  12. Re: 1999 honda 130 4 stroke new to honda thanks for any help

    To clear the code leave jump cable in, turn ignition on and activte kill switch 5 tomes in one second intervals, alarm will sound to indicate codes clear. If code retirns there is still a problem
  13. Re: 1999 honda 130 4 stroke new to honda thanks for any help

    Simply bridge the two wires and the code will flash
  14. Replies
    21
    Views
    343

    Re: 2002 bf225a. Spark and fuel but no Start

    So you replaced the throttle body?
  15. Replies
    1
    Views
    289

    Re: DF250 and 9.9 Winterizing

    Any outboard trimmed fully down will drain completely
  16. Replies
    1
    Views
    273

    Re: DF250 Digital Gage

    You cannot use any nmea accessory without the proper start up kit
  17. Replies
    1
    Views
    302

    Re: Trim Problem - Please help

    For trim shudder trim it fully up and then top up the oil, use 10w30 in an oil can to do this. As for trim speed, could be voltage drop or the trim motor is on its way out.
  18. Re: 2008 9.9 Power Thrust 4 stroke Remote to tiller conversion.

    Put power to the solenoid stud that connects to the starter cable and then ground the other cable and that will energise the starter
  19. Replies
    21
    Views
    343

    Re: 2002 bf225a. Spark and fuel but no Start

    Apologies Bill , my misinterpretation
  20. Replies
    2
    Views
    176

    Re: ECO Light on HD-4 G gauge

    The light comes on when engine is in eco mode, ie when it is leaned out to maximum for the rev range it's in. Generally if you are cruising it will come on, and then go out during acceleration or...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4