Logo

Search:

Type: Posts; User: guyjg

Page 1 of 4 1 2 3 4

Search: Search took 0.05 seconds; generated 10 minute(s) ago.

  1. Re: Mercury Black Max Issues: Year, HP, Trim / Tilt, Gearbox etc

    Most likely worn out solenoids. Yes, check for corrosion at the sockets. Does it trim at the throttle? If it does then it isn't the solenoids.
  2. Re: Mercury Force 40Hp making loud alarm tone when ignition turned to "ON" position

    The post you attached to is 4 yrs. old, start a new one for more help.
  3. Replies
    18
    Views
    8,256

    Re: Merc 200hp EFI 1996

    You have tagged onto a 5 year old post so start a new thread back at the beginning of the Mercury OB section. Include the engine SN and year. Doing this will get you 15-25 learned viewers to help...
  4. Re: 3000 CONTROLLER - THROTTLE ONLY BUTTON is not popping out

    Use a shop vacuum if you think it's necessary. WOT = Wide Open Throttle
  5. Replies
    1
    Views
    130

    Re: 01 mercury 4 stroke

    HP/ Ck for spark when it pukes out.
  6. Replies
    3
    Views
    191

    Re: 1994 40 HP Mercury

    Use a spare spark plug. Inspect the stator and trigger coils for hairline cracks that expand when they get hot and stop the spark.
  7. Replies
    6
    Views
    261

    Re: Lower Unit interchangeability

    Install a SS skeg cover.
  8. Re: 74 80hp Mercury External Power Trim Wireing Diagram please

    Buy a manual at your local boat parts store.
  9. Re: 2004 90hp Merc outboard startup after sitting 2 yrs tips

    Charge the battery or get a good starting battery, hope that the carbs were run dry, install new plugs if necessary, change lower unit oil if it is dirty, fog the cylinders if it's a 2-stroke, use...
  10. Re: 75 Mariner bogs down and then pow it takes off like normal

    /See if the accelerator pump is working. Rough idle could be dirty carbs. I use a spark gap tester on each wire set to 716" to insure the spark is getting to the plugs, is snapping loud and...
  11. Replies
    8
    Views
    513

    Re: Mercury 9.9 Fourstroke Starting Problem

    Sometimes the Seafoam method works but not in your case as faztbullet stated...time to take the carb apart and give it a good soak cleaning overnight. If you have access to a ultrasonic cleaner it...
  12. Replies
    10
    Views
    304

    Re: 96 50 horse merc froze, Help Please.

    Compression test?
  13. Replies
    10
    Views
    1,927

    Re: Water In Oil, engine seized

    Don't forget the cam must be changed in a truck engine.
  14. Re: Desperate for help!!!!!! 1985 Mercruiser 470 backfires!

    Fellas...Aug 2011 was last post before you.
  15. Replies
    36
    Views
    4,822

    Re: Mercruiser starts then quits...

    You're welcome.
  16. Replies
    4
    Views
    277

    Re: backfiring @ low rpm

    You're welcome...keep the post going if you solve the issue and list what you found/did.
  17. Replies
    6
    Views
    834

    Re: Engine spline coupler question

    Start a new post for the most responses to it. Tagging to this post does not reach everyone available.
  18. Replies
    10
    Views
    1,927

    Re: Water In Oil, engine seized

    Ck the engine coupler for damaged/worn gear teeth. Replace now w/engine out. Examine the floor, stringers, engine mount bases and transom carefully for rot especially at the edges of any holes or...
  19. Replies
    23
    Views
    4,425

    Re: Bravo 3 - R/R Gimbal Ring - While There... ?

    Caution when removing oil fill line from the reservoir to the OD. The pass thru part is plastic and hardened OD oil hose is difficult to disconnect from the plastic nipple. I just cut it then when...
  20. Replies
    4
    Views
    277

    Re: backfiring @ low rpm

    Cylinder compression good? Dirty spark arrestor? Water in the fuel? Spark plugs good? Injectors dirty? Try a double dose of Merc fuel injector cleaner or equal like Seafoam. Watch the engine...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4