Logo

Search:

Type: Posts; User: RobertFL

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    163

    Re: 1999 Honda 90 HP Tilt/Trim

    I had my 1997 Showa TnT unit rebuilt last year due to leaks at all 3 rams. I took a few pictures before sending it to the rebuilder. In this pic you can see the fluid fill cap in the upper left and...
  2. Replies
    6
    Views
    163

    Re: 1999 Honda 90 HP Tilt/Trim

    23501
  3. Replies
    6
    Views
    163

    Re: 1999 Honda 90 HP Tilt/Trim

    Have you checked the Tilt/trim fluid level?
  4. Replies
    8
    Views
    361

    Re: Honda BF90A hose

    I have a 1997 BF90. I looked at mine and there is a 8 inch piece of clear tubing attached to the nipple you are pointing at. The tubing is open at the end and looks to be a vent? I did not see the...
  5. Replies
    5
    Views
    309

    Re: Tilt and Trim Sending ?

    on my 1997 BF90 the trim/tilt angle sending unit is located on the left stern bracket next to the trim and tilt unit
  6. Replies
    5
    Views
    288

    Re: What is this? 1998 BF75A Connector

    My boat sat under a oak tree for 7 years before I got it. I was lucky that all I had to do was rebuild carbs, change fluids, new impeller...The tilt and trim both worked but leaked at all 3 piston...
  7. Replies
    5
    Views
    288

    Re: What is this? 1998 BF75A Connector

    I have a 1997 BF90 Honda. I looked at mine today and did not see anything like your picture.
  8. Replies
    9
    Views
    406

    Re: Bf90 low compression

    I'm not a mechanic.. I always engage the kill switch before running any compression tests, I was told you can mess up the ignition or stator? if the electric has no where to go. but on a lawn mower...
  9. Replies
    2
    Views
    139

    Re: 1998 BF90 Hydraulic Tilt not working

    My 1998 BF90A Trim n Tilt worked well but sometimes would hang up at full tilt, I would have to open the manual screw to drop it, then it was fine until I raised it fully again.. I think it may of...
  10. Replies
    2
    Views
    139

    Re: 1998 BF90 Hydraulic Tilt not working

    no expert myself...but maybe you have an internal valve problem? Also you may have to run a few more up/down cycles to work more air out of fluid, run a few cycles, fill with fluid, let it sit an...
  11. Re: BF40 idling issues, opened it up, discovered this...

    Glad you got some good info and a easy fix..I was not sure if you had to use a special grease on the push rod or special anti seize on the bolts... I would order a new "O" ring along with the pump,...
  12. Re: BF40 idling issues, opened it up, discovered this...

    Chunchy, No screens on mine just an inline filter just before the fuel pumps. I installed a water separator type fuel filter onto the transom between the engine and fuel tank.
  13. Re: BF40 idling issues, opened it up, discovered this...

    Texas, It looks like an easy fix, having never replaced one there may be a trick or two.. some research might be needed . Since my engine has 2005 hours on it I will be replacing the fuel pump "push...
  14. Re: BF40 idling issues, opened it up, discovered this...

    Thats the fuel pump. As far as I know there are no rebuild or gasket kits available. I have a 1997 BF90a that has 2 fuel pumps and one just started a small drip also. I have to buy a new fuel pump or...
  15. Replies
    3
    Views
    216

    Re: 1997 BF90 lower unit seal kit options

    I bought a boat last year with a 1997 BF90A and am slowly working on it, engine is good but am working on the boat itself. My lower is Mercury....
Results 1 to 15 of 15