Logo

Search:

Type: Posts; User: RicardoMarine

Page 1 of 4 1 2 3 4

Search: Search took 0.09 seconds.

  1. Thread: Starters

    by RicardoMarine
    Replies
    4
    Views
    26

    Re: Starters

    The HTGR/PMGR (high torque gear reduction/permanent magnet gear reduction) starter motors will out perform the old non-gear reduction motors hands-down.
    Chrysler has been using a high torque gear...
  2. Replies
    11
    Views
    70

    Re: 2011 3.0 engine swap

    The distance from the rear engine flange (where the flywheel cover mates) to the actual surface of the flywheel, should be identical between the two engines.

    22305




    If you change from a...
  3. Re: Aloha all...need a transom template for a VP 275 sterndrive

    By chance are you near a boat salvage yard?
    If so, see if they will allow you to make a template from a boat that has had the 270 thru 285 transom shield removed.
    Be sure to include the X...
  4. Re: Engine mount lag bolts not holding after being repaired.

    Stringers and/or engine mount towers are always fiber-glass bonded to the boat's hull.
    We will see individual stringers with a separate engine mount tower (such as what you may have), and will see...
  5. Replies
    13
    Views
    126

    Re: Sunbird cuddy no motor

    JLG, my unsolicited advice/suggestion:

    Don't shoot yourself in the foot by holding out for a top price for an ole Stringer Drive.
    You would need the exact right buyer for one of these, and they...
  6. Re: Engine mount lag bolts not holding after being repaired.

    Unless they had removed more of the bad core material prior, the epoxy fix was not a good choice.



    What ever they do, and who ever does this for you, make sure that they only cut open the tops...
  7. Replies
    24
    Views
    2,100

    Re: noisy out drive Volvo penta

    No, I was merely trying to add in what my symptoms were to aid others. I'm aware he had a later drive, but thought my comment would have been of assistance to those who currently have bad gimbal...
  8. Re: rpm gauge not working after new engine installed?

    ........................





    The tachometer receives it's power via the ignition key switch while in the run mode. It will be powered by the same means as your other instruments!
    The...
  9. Re: Good outdrive paint for volvo penta

    During these years of production, the factory color was what VP called Aquamatic White.
    Although they eventually went to a slightly darker grey color (C and later models), your DP-A will likely be...
  10. Replies
    17
    Views
    228

    Re: 290 shifting into reverse problem

    I'm thinking that you meant "coupling rod", which is shown as SEQ #3 and Volvo Penta p/n 814397 in this schematic.
    ...
  11. Re: older 4 cylinder mercruiser Identification?

    FYI....... The timing tape or Degree Decal (such as Mr. Gasket or MSD) must be a match for the harmonic balancer diameter. ...
  12. Replies
    24
    Views
    2,100

    Re: noisy out drive Volvo penta

    All too often an OP (original poster) does not come back and put closure to his/her thread, such as with this thread. Since this one is just over 5 years old, I doubt that the OP will even see your...
  13. Replies
    13
    Views
    126

    Re: Sunbird cuddy no motor

    I'm with Chris. You will be better off with the canoe.

    You will want to avoid buying any boat with a stringer drive, or any OMC drive for that matter!

    .
  14. Replies
    8
    Views
    6,762

    Re: 3.0 years that can swap

    This thread was started back in September of 2011.

    Best to start a new thread!
  15. Replies
    17
    Views
    228

    Re: 290 shifting into reverse problem

    .................
  16. Re: older 4 cylinder mercruiser Identification?

    https://forums.iboats.com/filedata/fetch?id=10622674&d=1532661730
  17. Replies
    8
    Views
    6,762

    Re: 3.0 years that can swap

    This thread was started back in September of 2011.
    You'll get better results if you were to start a new thread!




    .
  18. Re: older 4 cylinder mercruiser Identification?

    You want to see an ignition advance curve for the Marine engine, not necessarily a torque curve.

    Also, from what I see, that is a manual for the industrial 3.0L engine, EST ignition system, and...
  19. Replies
    17
    Views
    228

    Re: 290 shifting into reverse problem

    ..............



    22271
  20. Replies
    8
    Views
    205

    Re: Need relacement crusader 454s

    Regarding over-hauling your existing engines..... were these raw water cooled, or were they fitted with Closed Cooling systems?

    If raw water cooled (at that age and hours), you would not want to...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4