Logo

Search:

Type: Posts; User: Rjcamel2355

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. 1999 ox66 3.1l 200 Yamaha surging/fuel issues

    Hey folks,
    I have a 1999 Yamaha 3.1l. Motor has never gave me any trouble in 5 or so years of owning it.

    I replaced the spark plugs, lp pumps, vst filter cleaned the o2 sensor and fuel bowl...
  2. Replies
    14
    Views
    221

    Re: 2004 130hp Honda fuel problem

    Solved! Someone had the valve cover off at some point. The fuel pump lifter was completely turned around not even touching the cam. Flipped it around and it runs like new.
  3. Replies
    14
    Views
    221

    Re: 2004 130hp Honda fuel problem

    Test was done in the water, I just put it on the hose to start it so I could see if the pump on the back was functioning.

    However I went home and tested it per your instructions. I tried turning...
  4. Replies
    14
    Views
    221

    Re: 2004 130hp Honda fuel problem

    Fairly certain it's the pump on the back of the motor. I can crank the motor and even start it with the hose disconnected from the exit side of the pump and it never squirts fuel.


    Is there a...
  5. Replies
    14
    Views
    221

    Re: 2004 130hp Honda fuel problem

    Just tried to run it. In neutral you can rev it up all day. Itll idle just fine. If I put it into gear and rev it up or try to run it for 2 minutes or so it does fine and then it starts surging and...
  6. Replies
    14
    Views
    221

    Re: 2004 130hp Honda fuel problem

    Right, That's what I have (I guess I didn't describe the canister- aka fuel pump- correctly). Thats the picture of the motor I currently have.
  7. Replies
    14
    Views
    221

    Re: 2004 130hp Honda fuel problem

    https://m.imgur.com/a/DrBF95d

    Here is the fuel system as far as i can tell.
  8. Replies
    14
    Views
    221

    Re: 2004 130hp Honda fuel problem

    I fixed the fuel leak replaced the primer bulb and hose and changed the oil. hopefully that is all that it needed
  9. Replies
    14
    Views
    221

    Re: 2004 130hp Honda fuel problem

    Just picked the boat up its sat for a few years it seems, took it out and had the fuel issue so I'm trying to correct that now. The drain runs from the fuel pump into the front of the block?...
  10. Replies
    14
    Views
    221

    2004 130hp Honda fuel problem

    Hey folks I have a 04 Honda 4 stroke that's having some issues with fuel. Can run around on the lake a bit then it starts cutting out, can pump the bulb and itll pick back up. I was looking at the...
  11. Re: Tilt and trim 150 mercury oildyne system help

    9-18611 is the Mallory part number. Of the plastic tank I found.


    On another note. The pee stream on the motor seems kind of weak to me. But my water pressure gauge reads 10+ psi at idle and...
  12. Tilt and trim 150 mercury oildyne system help

    Hey guys. Got a 150 mercury with the tilt and trim inside the hull. 6569864 is the engine serial number. I have a pinhole in the tank that holds the oil. The metal style one. Is there a replacement...
  13. Replies
    0
    Views
    158

    Help 200hp mercury choke issue

    Hey guys I have a 200hp mercury black max. Tried it out today. Got it started and went to take off. Engine died. Tried a few more times same results.

    Pushed the choke in for a split second and it...
  14. Re: Mercury 200hp v200 oil injected black max questions

    Swapped the packs today. Got bright blue strong spark on all plugs. Fired it up on the hose, seems to idle good, but when I give it throttle by the linkage or through the throttle handle it wants to...
  15. Re: Mercury 200hp v200 oil injected black max questions

    Thank you fazt, the original owner had a 23p prop on this engine. It was pushing a 20-21' ranger. I'm going to be using it on a 17' Skeeter. Should I look at a larger prop? Or just see what I have...
  16. Re: Mercury 200hp v200 oil injected black max questions

    0b169504 is the serial number on the clamp.

    Horizontal reeds from what I can see, 82 jets in 1 and 6 all others are 80's

    No spark on cylinder 6, even when swapping coil wires. Gonna put a...
  17. Mercury 200hp v200 oil injected black max questions

    I was given a 200HP mercury today. Not sure of the year. I'll get the serial number tomorrow. Ran a compression on it and all cylinders seem to be around 120psi.

    Dirt dobbers have had a party...
  18. Re: 1984 Mercury 150 (Got a few questions)

    Ran the boat today:

    Found a hole in my fuel pump diaphragm and swapped it with a used pump diaphragm I had laying around. Boat ran great for 5-10 minutes then it shut down. Pumped the bulb and...
  19. Re: 1984 Mercury 150 (Got a few questions)

    Got it on the lake this afternoon, idled perfect put it into gear and took off. Jumped up on a plane good ran 5300-5500ish on the tach.

    Got about 150-200 yards and it sounded like it ran out of...
  20. Re: 1984 Mercury 150 (Got a few questions)

    Replaced the needles today .All fuel hose from the tank to the carbs is new. Installed a fuel filter. Replaced the impeller and fired it up. Idled on the hose with a 4-5' long stream of water...
Results 1 to 20 of 53
Page 1 of 3 1 2 3