Logo

Search:

Type: Posts; User: sandkicker

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Re: Oil and water spewing out of flame arrestor - 305 Merc

    start by checking compression
  2. Replies
    14
    Views
    12,415

    Re: mercrusier 1987 470 voltage regulator issue

    RE: ....to open the positive output of the voltage regulator ..I used a 20 ft long 2 conductor power cord #16 ga. wire ...

    what occured surprised me as the power cord dropped the output by ...
  3. Replies
    12
    Views
    81

    Re: v drive help

    If it is 30 wt, you need to drain it out... may have to use a pump thru the dipstick/fill hole
  4. Re: Volvo DP Cotrim Outdrive stock on Neutral.

    Yes, you have a leak. Volvo drives in good shape are both pressure and vacuum tight... there should be NO oil leaks from anywhere. Doubt if oil level in drive, when up, reaches that high anyway (@...
  5. Re: Volvo DP Cotrim Outdrive stock on Neutral.

    Outdrive in up position for long time not a good idea...
    OIL in the bellows ????
  6. Re: Could water ears flood a mercruiser v8 if engine not running ?

    .... not to be picky, but they're called (exhaust) elbows.... some engines have elbows AND risers, so the distinction is not trivial. There are gaskets between the manifold and elbows. There can...
  7. Replies
    5
    Views
    66

    Re: 19692T01 Pulley Removal

    Old trick, like changing a car tire... loosen bolts one flat or two before removing belt...
  8. Re: Gear Box Transmission Clatter in Model 275

    Re: # 6 1400 rpm shifts are not recommended and when done result in loud noises.... and reduced tranny life. Normal shifting done @ 650.
  9. Re: Could water ears flood a mercruiser v8 if engine not running ?

    A crack in the exhaust manifold would do it...
  10. Replies
    4
    Views
    50

    Re: Steering actuator leak.

    model number of engine/drive please.
  11. Replies
    5
    Views
    66

    Re: 19692T01 Pulley Removal

    If has 4 bolt holes per picture in the link, no puller should be necessary unless its rusted on or painted on ... a favorite Mercruiser gotcha...
    .
  12. Re: Could water ears flood a mercruiser v8 if engine not running ?

    No....Bondo did not suggest your said too much...
  13. Re: problems with resealed Frankenstein AQ outdrive

    What kind of oil did you put in the drive ???
  14. Replies
    6
    Views
    98

    Re: AQ171c Plug wire placement

    ...I believe its the 4 banger...
  15. Re: replacing waterpump impella and its v belt problems.

    .....and while you are at it, replace the oil in the water/fuel pump housing. It takes "gear oil" i.e., SAE 90. Inspect old oil for contamination.
  16. Re: replacing waterpump impella and its v belt problems.

    Easiest fo disco fuel lines at the pump itself... REmove whole assembly... Issues with the pulley/lock easier to deal with on a work bench...
  17. Re: replacing waterpump impella and its v belt problems.

    NEVER need to take the pulley off to replace the impeller!!!


    1)Remove belt after loosening adjuster on idler pulley.

    2)Disconnect fuel and water lines ( make note, i.e. MARK THEM ...
  18. Replies
    6
    Views
    98

    Re: AQ171c Plug wire placement

    Most disti caps have the cylinder number stamped/molded into them for every wire....
  19. Re: 1989 Mercruiser 5.7l Randomly slowing down/dragging?

    Which drive??? Alpha??? Bravo ????
  20. Replies
    8
    Views
    113

    Re: Volvo Penta fuel issue

    It won't....
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4