Logo

Search:

Type: Posts; User: lethal_lee

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    2,063

    "Couple of things? What is cl

    "Couple of things?
    What is clicking the starter or the starter relay?
    What model 44 have you got A/B/C?
    If you have 44A/B, try moving the power supply cables for the shift actuator on the...
  2. Replies
    2
    Views
    1,437

    "Hi Engine is shutting down b

    "Hi
    Engine is shutting down because to much current is being drawn by the actuator and it can not select neutral!!Better be safe then sorry
    Caused by tight shift cable/worn or tight shift...
  3. Replies
    1
    Views
    467

    "Hi Craig 6:3 is fuel temp

    "Hi Craig

    6:3 is fuel temp sensor in injection pump,Check large round plug on fuel pump loom for lose/corrosion/water present or push back terminals on pins 5&6
    If you have a multimeter handy...
  4. Replies
    3
    Views
    2,063

    Hi Could be start relay in el

    Hi
    Could be start relay in electric's box???.Check all cables to and from.When he replaced all of the wiring do you mean engine loom aswell? Theres a difference between 44A's and B's looms?
  5. Replies
    3
    Views
    750

    Hi may be a smaller set of pro

    Hi may be a smaller set of props might be needed if your carrring alot of weight around?
    and yes i can see what software is running!!!
  6. Replies
    1
    Views
    331

    "Matt next time you go to the

    "Matt next time you go to the boat check for air at the bleed screw on top of the engines double filters,remove any air,tightern screw,prime pump some more then try starting?sounds like fuel...
  7. Hi Bruce there was also a se

    Hi Bruce
    there was also a service bulletin with the gearshift sector units in the drives if your running dp-h drives.Get serial numbers checked with dealer.Theres a replacement part.
  8. Replies
    2
    Views
    409

    Hi steve your on the right li

    Hi steve
    your on the right lines.If there no coolant in the bilge and no hot water takeoffs then the coolant must be going out the exhaust?I would check the heatexchanger first its the main part...
  9. Replies
    2
    Views
    376

    "Hi have you checked it with

    "Hi
    have you checked it with a manual gauge on both units at the same time,may just be electrical?

    rattly???valves,injectors?check valve clearances first?any service history?"
  10. Replies
    1
    Views
    5,301

    there is a control module in t

    there is a control module in the electric box. it contols the negative supply to the clutch.the positive supply comes from the starter motor and is live as soon as the battery switch is on.the...
Results 1 to 10 of 10