I have a 2009 DF90A and my fuel bulb doesn’t get hard, never has. I’ve always ASSUMED the low pressure fuel pump feeds the VST and the high pressure pump is sufficient to supply fuel. Your...

“as if I had turned it off”

Electrical?

Did you check your battery terminals, all tight and clean? Look for a white wire that should come off the battery positive post, I think there is a 15...

My main jet isn’t a hex but a flat screwdriver, not much bigger than a set screw. With excellent light a great magnification I see 105S. There is something before the 1 in 105S and I think it might...

Yes that’s the one

Not the muffler housing, the Silencer Cover.

Stuff happens, got new gaskets coming next week. I thought of reusing the gasket but during the cleaning process nothing jumped out at me that would explain why the engine was/is running like it...

https://www.suzukioutboardforum.com/forum/general-discussion/suzuki-outboard-parts-forum/4690-how-to-set-engine-height-select-the-right-prop

Some reading material that might help you. If a...

Ran into a snag. Accidentally tore one of the carburetor gaskets. The tear goes from the long flange bolt hole to the outer edge.

I’m guessing this gasket is NFG?

28694

The 10:00 and 2:00 o’clock atmospheric found deep inside the float chamber, cleaning solution makes it’s way out the carb quickly, I fill the little chambers(looking into the float chamber from the...

Idle speed orifice found at the 1:00 o’clock position.

Transition orifice found, only found one. With the throttle plate closed this orifice is almost covered by the edge of the throttle plate...

Let me find the rest of the orifices you are talking about first and I’ll see if I can get cleaner through them on my own. I’m cooking supper and watching hockey tonight GO OILERS! so won’t be...

When I stuff the cleaner straw in the orifice where the jet nozzle came out of I get a good stream of cleaner coming out of the 5 or 6 holes in the throat, the steam is hitting the throttle plate and...

All parts you mentioned above are out. My brass plug is a slotted for a flat screwdriver. Couldn’t find suitable snap ring pliers so the accelerator pump piston will have to stay in place. As I was...

Rest your fingers this project is not time sensitive. I have snap ring pliers just not small enough to fit into the hole, I’ll go looking around the lake and see if I can find a suitable pair. I...

Many thanks, I just needed to be more aggressive. Carburetor is disassembled as per service manual. The throttle lever and all components associated with throttle are still on the carburetor...

To make sure I’m doing this correctly I will be prying the black plastic linkage pivot off the throttle lever. When I get the throttle cable disconnected the black plastic linkage pivot will still be...

Sorry about the double post, still learning the Ipad and all its features

The easy stuff to remove is removed, flange bolts that hold the carburetor on are finger tight. My issue is removing the throttle cable holder, the bolt is removed but the slot above the two small...

The easy stuff to remove is removed, flange bolts that hold the carburetor on are finger tight. My issue is removing the throttle cable holder, the bolt is removed but the slot above the two small...

I’m “game”! I have the gasket set, Item 1 you referred to coming tomorrow, failing that Honda will ship it. I have a service manual so I’ll be able to follow that for the big picture.