Logo

Search:

Type: Posts; User: racerone

Page 1 of 4 1 2 3 4

Search: Search took 0.12 seconds; generated 55 minute(s) ago.

  1. Re: 50 hp Evinrude works prefect in reverse and neutral but has low RPM's in Forward

    Nope-----When a 2 stroke carburetor goes empty there is lots of oil all over the parts and no damage is done !!!!-----There are no warnings on portable fuel tanks about running a tank empty.----Never...
  2. Re: Need help finding model and serial numbers

    All the numbers you have posted including 848-5031 and 848-5037 have nothing to do with identification of your motor !!----Learn to post pictures of this thing to get the help you want !
  3. Replies
    45
    Views
    148

    Re: Johnson 115 timing help

    #1 is the very top cylinder on the starboard side.-----The one below it is #3------Now on the port side the top is #2 and the one below is # 4-----I believe there is something very simple wrong with...
  4. Replies
    45
    Views
    148

    Re: Johnson 115 timing help

    It will start and run on 2 cylinders out of the water.----It will rev up fine on 2 cylinders out of the water.------Means nothing.-----Did the motor run fine for you last year / last month ?----What...
  5. Replies
    3
    Views
    32

    Re: Johnson 200 horse fuel pump

    Everybody works to a different standard.------There is a 2 pump combination type set-up available ( mastertechmarine ) or I know I would install 2 pumps from say a 1966 model 100 HP Johnson.----Those...
  6. Re: 1987 Johnson 70hp no spark after sitting for a few days

    First thing I would do is load test the battery, even if it is new.----Often a free service at many battery sellers.
  7. Replies
    4
    Views
    47

    Re: 2014 40HP 4 Stroke Lower Unit Knocking

    Check the gear oil.----Remove propshaft bearing carrier to evaluate condition of the gears.
  8. Re: 1990 evinrude 120 water control valve delete

    Fazt----Is merely stating that parts for this conversion are found on the 3 cylinder motors.----Similar parts for the thermostat cover on those.-----Last I looked Faztbullet is not being paid by the...
  9. Thread: 40r73d

    by racerone
    Replies
    10
    Views
    67

    Re: 40r73d

    The factory generator was similar in size to the starter motor.------Output of 10 amp at full throttle.----Not too hard to find in my area.------Not sure how many were sold in Turkey.
  10. Replies
    45
    Views
    148

    Re: Johnson 115 timing help

    Check the flywheel key.
  11. Replies
    45
    Views
    148

    Re: Johnson 115 timing help

    Start the motor and let it idle.------Pull one sparkplug lead off at a time.-----Report what happens.-----If spark is out by 180 degrees the motor would not run at all !!
  12. Replies
    2
    Views
    36

    Re: Help with tilt trim issues

    If it has the 2 external tilt / trim rams you can mount a MERCURY / MERCRUISER pump unit to provide oil pressure.-----The unit mounts inside the boat out of the elements.
  13. Re: 50 hp Evinrude works prefect in reverse and neutral but has low RPM's in Forward

    In neutral there is NO LOAD and the motor would rev up on just 1 cylinder so that means nothing.-----In reverse there will be lots of exhaust in the water and that also reduces the load.------Do a...
  14. Replies
    10
    Views
    53

    Re: 1996 evinrude 115hp stalls under load

    Shift rod to the lower unit has nothing to do with timing.
  15. Replies
    3
    Views
    33

    Re: 1986 90 hp maybe new to me

    The 90 HP models did not come with " bubble back " exhaust.-----Buyer beware I say.------But it could be a good rebuilt one.---You just never know.
  16. Replies
    3
    Views
    33

    Re: 1986 90 hp maybe new to me

    The piston ring problems were from 1975 to 1998 on all crossflow V-4 motors !!
  17. Replies
    5
    Views
    49

    Re: 9.5hp evinrude no spark to top piston

    Check plug wires for cracks where it comes out of the magneto plate.----And are the coils original ?------Most have failed and it likely has a replacement set !
  18. Re: 1986 Mercury 25XD Powerhead Reinstalled / Smoke Thru Pee Hole-No Water

    Water in your test bucket must be 8" above the impeller.
  19. Replies
    45
    Views
    148

    Re: Johnson 115 timing help

    What are you calling the #1 cylinder ?-------Top on starboard side ?------Bring that cylinder to tdc and verify your timing marks and timing pointer.----Did you have the coils off the motor and made...
  20. Replies
    19
    Views
    135

    Re: Help ID Johnson 90 VRO (many pics)

    ?---Just 2 screws and the starter comes apart.-----Use a digital ohmeter to take a reading from the commutator to the shaft.----Should read infinity.---Use a paint scraper or piece of sheet metal...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4