Logo

Search:

Type: Posts; User: racerone

Page 1 of 4 1 2 3 4

Search: Search took 0.23 seconds.

  1. Replies
    4
    Views
    70

    Re: Temp Alarm at startup

    Maybe the buzzer itself is defective.----What light stays on ?------Model # of this engine ?
  2. Re: 1977 140 hp Evinrude, no power, won't get up on plane

    Timing needs to advance BEFORE you can open throttle plates.----If timing does not advance the motor will die on you !-----This 2 stroke is a different machine than ---" grandpa's 283 Chevy "
  3. Replies
    7
    Views
    64

    Re: 1994 Johnson 15HP J15RERE

    Then no need to jump all over the pump.------Why not test your motor ?----If operation does NOT improve with operation of the manual pump, the pump on the motor is working just fine.-----If operation...
  4. Replies
    2
    Views
    23

    Re: Water pump on a Johnson 5.5 hp CD 17

    Yes it does.----Just 7 screws, linkages and hoses.-------Bonus is that it allows you to inspect the mechanical seal on top of driveshaft.------Note , in my opinion it is good / practical...
  5. Re: 1977 140 hp Evinrude, no power, won't get up on plane

    Fact-------The maximum timing advance is set at the factory ( 28 degrees ) and generally does not need adjusting for the life of the motor.------Then there is idle timing and it looks after...
  6. Replies
    7
    Views
    64

    Re: 1994 Johnson 15HP J15RERE

    Pressure operates the fuel pump.------The pressure on the diaphragm compresses the spring and pushes fuel to the carburetor.-----Then the spring pushes the diaphragm back to pull fuel from the...
  7. Replies
    7
    Views
    64

    Re: 1994 Johnson 15HP J15RERE

    The impeller is rubber.-----Rubber is not a " permanent " product.-----Rubber deteriorates with time.-------The motor does NOT have an overheat warning buzzer or an overheat shutdown system.------On...
  8. Replies
    3
    Views
    29

    Re: 1971 johnson evinrude 85 hp

    Find the safety switch on the engine block.----Starboard side.----It has just 1 white wire on it.-----That switch might need internal cleaning or adjusting.-----Motor will not crank if throttle is...
  9. Replies
    23
    Views
    228

    Re: 1982 Johnson 2 hp won’t start or fire

    There is no fuel pump on that little 2 hp motor !
  10. Replies
    23
    Views
    228

    Re: 1982 Johnson 2 hp won’t start or fire

    A motor in good condition starts right up.----Resorting to an electric starter on a 2 hp is not good practice.----Motor needs 4 thing to run.----Correct amount of fuel at 40:1 mix.----Strong spark (...
  11. Re: Tohatsu 9.8a impeller: and the dilemma of discontinued parts on usable, high quality outboards

    I believe that there are many impellers that can be adapted.-----Takes time to research dimensions on the many different one.
  12. Replies
    23
    Views
    228

    Re: 1982 Johnson 2 hp won’t start or fire

    It is a 1 cylinder motor.-----Compression heats up the air.------Clean carburetor and inspect reed valves.
  13. Re: Why is my 3cyl 25hp 2-stroke bogging down???

    Use your timing light and check it out.-----The trigger unit with optical sensor is rotating as it should be ??
  14. Re: Why is my 3cyl 25hp 2-stroke bogging down???

    Oil injection unit is gone !----And no those fittings / holes had nothing to do with mounting the oil injection.----Water pressure and temperature gauge sender come to my mind.
  15. Re: Why is my 3cyl 25hp 2-stroke bogging down???

    The pumps operate with crankcase PRESSURE and not so much vacuum..-----If the oil injection unit is still on there you should take it off and throw it away as far as you can.
  16. Re: Gas/oil leaking through center of the prop, at times.

    Install a new diaphragm in the fuel pump.
  17. Re: Gas/oil leaking through center of the prop, at times.

    Model # of this motor ?-----If the bulb does not go hard you could have a ruptured diaphragm.-----Easy fix if you are interested in checking / fixing that simple pump.-----But some leakage out the...
  18. Replies
    3
    Views
    49

    Re: 1996 30hp 2-Stroke Oil Leak E30ELED

    I believe there is a wee hose that goes from the bottom of the motor block ( near the front ) to the the top bearing.----Look for it and replace if it is leaking.
  19. Replies
    5
    Views
    32

    Re: Merc 500 Hard to start.

    These motors are notorious for bad / rotted wiring.---So inspection is required.------First check compression.-----Simply because you need to know condition of motor before spending the beer tokens...
  20. Re: 1977 140 hp Evinrude, no power, won't get up on plane

    Well -----100 PSI on one of those is no good.----It is a 2 stroke and has to smoke.--------So I will step aside until you do some real trouble shooting !!!-----It only sounds ---" perfect "----To the...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4