Logo

Search:

Type: Posts; User: pvanv

Page 1 of 4 1 2 3 4

Search: Search took 0.03 seconds; generated 32 minute(s) ago.

  1. Replies
    2
    Views
    30

    Re: Need a trim sensor for 2012 MFS30B

    Yes. Make sure you get the harness for it too.
  2. Replies
    1
    Views
    32

    Re: water flow from water pump 9.8hp 2 stroke

    Try compressed air to the discharge nipple while running.
  3. Replies
    1
    Views
    28

    Re: MFS98A3. Proper oil change instructions

    Patience. It takes several minutes to show on the stick.
  4. Replies
    1
    Views
    40

    Re: water pump help for a 99 Nissan, NS140A2

    There are 3 parts to the upper seal. The locking rubber keeps the tube in place. We would typically pull the powerhead to replace the tube.
  5. Replies
    8
    Views
    188

    Re: NS70A will not start

    I have two reprint manuals, $30.00 each plus postage. One is for the M50C/60A/70A2, the other is for the M55B/70A.
  6. Thread: Tohatsu Parts

    by pvanv
    Replies
    53
    Views
    10,091

    Re: Tohatsu Parts

    What is your actual model/serial?
  7. Replies
    7
    Views
    86

    Re: Missing Electrical Remote Connection

    Then just plug in the RC cord. And the TT wires.
  8. Replies
    7
    Views
    94

    Re: Nissan 2011 Outboard NSF4C Gas in Oil pan

    They are vents and can route via tubing out the lower cowl. Use 10w-30 oil.
  9. Replies
    7
    Views
    94

    Re: Nissan 2011 Outboard NSF4C Gas in Oil pan

    Diagnose the motor to get it running, then check the rest. Remember that a wet plug is either flooding or no spark; dry is no fuel.
  10. Replies
    7
    Views
    86

    Re: Missing Electrical Remote Connection

    Whip out your Factory service manual (available from any dealer, including me), and use it as a guide to match up the individual colors in your harness with those on the motor. If you had a control...
  11. Replies
    7
    Views
    94

    Re: Nissan 2011 Outboard NSF4C Gas in Oil pan

    Probably flooding or misfiring. How does the motor run?
  12. Replies
    7
    Views
    86

    Re: Missing Electrical Remote Connection

    You have the wrong RC box. In Nissan, you need an RC9B (3AFQ843300) for NSF30B w/PTT. You can also use the Tohatsu RC5A for PTT or RC5B if no PTT needed. What did the RC4 connect to before? What...
  13. Replies
    6
    Views
    660

    Re: M90a Lower pivot tube bushing

    Yes, but it will test your patience and tool assortment.
  14. Replies
    2
    Views
    56

    Re: Fuel / Oil Filter

    Cool. Glad you got it.
  15. Thread: Slow tohatsu 50!

    by pvanv
    Replies
    1
    Views
    75

    Re: Slow tohatsu 50!

    What is your actual model? What is the WOT RPM? What pitch prop? What do the plugs look like?
  16. Re: Remote to Tiller Conversion 2011 Tohatsu MFS20C w/ Electric Start

    In most cases, it's cheaper to sell the old motor and buy what you need, but it can be done as you ask.
    These is no kit, but you can buy parts from any dealer.
    You could keep the RC box, and just...
  17. Replies
    7
    Views
    129

    Re: Cylinder Head Water Jacket Hole

    You could hone the cylinders and install new rings.
  18. Replies
    1
    Views
    83

    Re: 2004 Nissan 40 TLDI

    Assuming you have an NSD40B. Year is irrelevant, but model is critical. You can DL your owners manual for free from the mfg website. You must prime the oiling system before initial startup, purging...
  19. Replies
    7
    Views
    129

    Re: Cylinder Head Water Jacket Hole

    Normal. No worries.
  20. Replies
    3
    Views
    101

    Re: Tohatsu 50D2 port for syncing?

    Actually, on the port side of the inlet manifold is a balancing tube that connects for each cylinder. You can use those ports. Honestly, if you sync idles from zero (closed all the way) you will be...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4