Logo

Search:

Type: Posts; User: faztbullet

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Re: 1973 Evinrude 65hp - Replacing vintage tilt/trim motor/reservoir/pump

    That a tilt unit and will not lift motor when underway...dont think the Amazon one will work.
  2. Re: Final word on lower unit oil? 1973 65HP Evinrude Outboard

    As long as it a 80/90W marine oil
  3. Replies
    16
    Views
    124

    Re: prop diameter vs. pitch

    All you want is to transfer as much torque to water as possible. A set of tabs will let you slow crusie and stay on plane.
  4. Replies
    2
    Views
    33

    Re: Mercury tilt switch

    Yes..just remove the nut for testing only. Why you want to test??
  5. Replies
    20
    Views
    134

    Re: 1996 Mariner 40HP wont fire

    A bad rectifier can cause a stator to overheat and damage the coil windings on it....
  6. Re: 95 Evinrude 150 motor Boggs after 3000 RPM

    Heads don't crack on these motors.....could be the shift interrupter if lower unit misadjusted
  7. Replies
    16
    Views
    124

    Re: prop diameter vs. pitch

    Your motor is a 1.86 ratio and on that hull you need to stay in the 14+ diameter range...14.5 x19 will be real close
  8. Replies
    20
    Views
    134

    Re: 1996 Mariner 40HP wont fire

    Yes...the problem is you don't have enough voltage out to coils and the compression prevents a spark due to it being weak. Either the stator is not putting out or the rectifier/capacitor is failed in...
  9. Replies
    16
    Views
    124

    Re: prop diameter vs. pitch

    What type of hull and motor???
  10. Re: Can A Mercury 2.5 Be Stored Face Down On It's Front, Or Can't It?

    2.5/3.5 4-Stroke - Brunswick Marine in EMEA Download Centerhttp://download.brunswick-marine.com › 4 › outboard

    http://download.brunswick-marine.com › 4 › outboard
  11. Replies
    20
    Views
    134

    Re: 1996 Mariner 40HP wont fire

    Check DVA voltage from stator as either it is not putting enough out to charge capacitor in switchbox or switchbox may have something funky going on in it ….my bet as seen this problem a lot is the...
  12. Re: Evinrude 1995 130HP two stroke no spark on 3 cylinders

    Starter RPM low,battery cables or bad stator...
  13. Re: 2003 Johnson 150 (j150plstm) balance tubes

    The port one goes on bottom of air silencer.....
  14. Replies
    20
    Views
    134

    Re: 1996 Mariner 40HP wont fire

    How does "being fouled up inside" prevent it from jumping a open air gap?????
  15. Re: Can A Mercury 2.5 Be Stored Face Down On It's Front, Or Can't It?

    From the manual... which is online at the EMEA download center



    "Remove the outboard and hold it upright until the water is drained out. Keep the outboard in an upright position when carrying....
  16. Replies
    20
    Views
    134

    Re: 1996 Mariner 40HP wont fire

    Stator weak ..likely damaged from bad rectifier/regulator
  17. Replies
    2
    Views
    97

    Re: Cleaning 150 Carbs w/ Ultrasonic?

    I use a dealers ultrasonic to clean badly clogged carbs and my fishing reels :)…...really works nice on those tiny pull over tubes
  18. Re: Question on Balancing 1997 S150 Carbs

    No your motor is a 2 stoke and all you need is a sync and link on the shafts...4 stoke need to be balanced.
  19. Re: High water pressure and oil on gear housing - 1984 Mercury V150

    Back up a lil.....is the replacement powerhead a 2L???? Does it have one piece or 2 piece heads?
  20. Replies
    23
    Views
    232

    Re: 97 johnson 150 2 stroke running weird

    VS leaking or VRO bad....
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4