Logo

Search:

Type: Posts; User: faztbullet

Page 1 of 4 1 2 3 4

Search: Search took 0.03 seconds.

  1. Re: New in box optimax 115exlpto 2007? What should I do??

    The 06/07 a lot of electrical issues(genie),fouling problems and making oil. Saw this in the several dealer I subcontracted to.
  2. Replies
    12
    Views
    129

    Re: Lower unit interchange V6

    To get it rebuilt as it started out a DIY project till he found bearings pitted and water damaged. I was selling him the parts and free tech information when he was doing it...
  3. Replies
    12
    Views
    129

    Re: Lower unit interchange V6

    I had a DIY bring me his unit and he removed his with a barbell weight and vice grips. He clamped grips on shaft under splines and used weight to hammer out shaft..
  4. Re: 1996 Mercury Offshore Stator Compatibility issue

    Here is what I got...all bobbins measure 1076-1089 and off a running motor that blew. Been in shed for about a year.. PM me..:cool:

    2557525576
  5. Replies
    12
    Views
    129

    Re: Lower unit interchange V6

    Nope...splined at top and splined at bottom
  6. Re: 2001 250 ficht ram emm-> 1999 evinrude 200 ficht

    Block porting is different between a 250 and a 200, the 250 is closer to the HO port mapping. You could likely install it on the 200 but it wont turn it into a 250
  7. Re: 1956 Evinrude 30HP sputters but won't run.

    When you cleaned carb did you install new gaskets?
  8. Re: Engine slowing then goes back to full throttle.

    Need to stop running it till you find the problem source. It could be running out of fuel due to a VRO problem and that will lean the cylinders along with restricted/contaminated fuel. Is the RPM...
  9. Re: 1991 Mcercury Black Max Bogging and will not plane

    Not a good test...need a tester to see if it will jump a 1/4 air gap
  10. Replies
    1
    Views
    41

    Re: Mercury 60 Bigfoot

    Sounds like mechanical fuel pump failed and filled crankcase.
  11. Re: 1991 Mcercury Black Max Bogging and will not plane

    How are you testing spark?
  12. Replies
    37
    Views
    394

    Re: Ethanol vs Ethanol Free?

    I run the synthetic fuel in all my hand held 2 stroke equipment...use it and put it away and will work the next time needed.
  13. Replies
    8
    Views
    190

    Re: Carbon build up evinrude 115

    Start running some CarbonGuard in the fuel a couple of months before you plan and storing it it....
  14. Replies
    12
    Views
    129

    Re: Lower unit interchange V6

    Yep ...either take to dealer and pay them to pop em out with tool or see below,,
    1999 200hp Johnson / remove upper drive shaft (marineengine.com)
  15. Re: Help on lower unit propeller install older Mercury XR2 Black Max

    Yours dont use that seal/weed guard. thhe rubbing maybe due the hub not reseated since repair. Install it, torque nut to at least 50 LBS and run it
  16. Replies
    37
    Views
    394

    Re: Ethanol vs Ethanol Free?

    That is the liner from inside the fuel lines that has degraded...and E10 does not attract moisture from the air.
  17. Re: 1996 Mercury Offshore Stator Compatibility issue

    I will look in da shed.....
  18. Replies
    12
    Views
    129

    Re: Lower unit interchange V6

    Just swap the driveshafts and it will be fine.....
  19. Re: 1996 Mercury Offshore Stator Compatibility issue

    Thats a 1994 ignition system and no it will not work. The white wires are for the ignition ECM and CDM modules as stator will drive both if ECM fails.
  20. Re: New in box optimax 115exlpto 2007? What should I do??

    That year model has a ugly mean genie inside it, if it ever gets loose you will regret it.....
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4