Logo

Search:

Type: Posts; User: Jimmy Robichaud

Search: Search took 0.00 seconds.

  1. Re: Can I use mercury controls on a 2006 Honda 50 HP outboard

    No you cannot,the wire harness plugins as well as the control cables are different.
  2. Replies
    4
    Views
    264

    Re: honda 135 hp gives cooling alarm

    I am looking in the Honda shop manual,when you are standing in the boat, the first thermostat in front ,towards you, just next to the engine hanger is the 50 degrees two grooves. The one towards the...
  3. Replies
    4
    Views
    264

    Re: honda 135 hp gives cooling alarm

    With the boat in the water, remove the black plastic thermostat housing and both thermostats. Start the engine and wait about 10 seconds, the water should be coming out of the thermostat holes. If no...
  4. Replies
    7
    Views
    514

    Re: Honda 250 800 hour service

    Seven year old motor, they should be changed. You are going to need both exhaust manifold gaskets, as there are two in each manifold, and just behind there are round plugs that are removed with an...
  5. Re: Milky oil coming out of 04 Honda 225 intake

    The best thing you can do with this unit is do a leak down test, and listen where the air is coming out. If a leak down test fails , you will probably have to pull both heads off and look for...
  6. Re: Honda BF30D cilinder 3 does not work

    If compression and spark are good, your problem is most likely the carburetor. Take it apart again, and check the 2 brass tubes coming up from the float bowl going to the top . These are likely...
  7. Re: Replacing a Honda BF50 with a BF60

    The controls will work ,only thing you will be missing is your check engine light and battery charging light,
  8. Replies
    7
    Views
    627

    Re: Bf225 head bolts

    i have the real Honda manual ,as we are a Honda dealer !!!!!!!
  9. Replies
    7
    Views
    627

    Re: Bf225 head bolts

    There is no measurement of lenght in the shop manual .it just tells you to apply engine oil to the threaded section and the seating surface of the bolt. Loosely install the bolts in the head, and...
  10. Re: Honda 150 4 stroke starting problems

    Check if the neutral switch is working to complete the circuit, i have had a few that the small lever was bent.
  11. Replies
    17
    Views
    780

    Re: BF 60 A hiccup.

    Hook up an inductive timing light on the top plug wire , have somebody drive the boat while you stare at the light. while it hiccups the light will blink if it is a ignition problem
  12. Replies
    10
    Views
    534

    Re: 2003 225 no power under load

    I had a BF150 that was doing the same thing , it turned out to be clogged low pressure fuel filter. Also check out the high pressure filter, if it is brown it is probably clogged,sopposed to be green.
  13. Replies
    13
    Views
    394

    Re: 2004 Honda BF 115A beeping.

    Check the water separator in the fuel line on the motor, it has a float that detects water and turns an alarm.
  14. Replies
    2
    Views
    171

    Re: Bbjj honda 250 2016 anode zincs

    There are also six more that have to be replaced in the water passage on the block. Remove both exhaust manifolds, and you will see round caps that will be removed with an allen wrench. These are...
  15. Replies
    2
    Views
    236

    Re: 2017 Honda bf50d tach

    Set it at 2P
  16. Replies
    20
    Views
    455

    Re: Honda BF50 Alarm Mystery

    Your problem might be the small panel in the control box that might be shorted out due to salt water ,the one with the green light and overheat light.You might have to open up the box and disconnect...
  17. Replies
    3
    Views
    350

    Re: BF 150 Overheat **FIX**

    Thanks for the info
Results 1 to 17 of 17