Logo

Search:

Type: Posts; User: Bt Doctur

Page 1 of 4 1 2 3 4

Search: Search took 0.05 seconds; generated 39 minute(s) ago.

  1. Replies
    4
    Views
    4

    Re: 1979 260 , 350 wiring ?

    unplug the engine plug, hot wire to coil +, and jump slave ....................................
  2. Replies
    9
    Views
    335

    Re: Sierra electronic distributor for 318

    you can also get the magnetic setup and install it in your dist
  3. Re: mercruiser alpha one gen 1 shift problems

    Definitly, the pulling action in reverse pulls, when pushing for fwd, the casing moves but not the core
  4. Re: mercruiser alpha one gen 1 shift problems

    click to enlarge
    https://i.ibb.co/V2KdGBh/W-21450-Mercruiser-Alpha-one-shift-cable-kit.jpg
  5. Re: mercruiser alpha one gen 1 shift problems

    you physically removed the lower shift CABLE and not just the core? Have found core separation where the solid core comes thru the outer casing or the cable is broken just behind the gimbal housing...
  6. Re: Barnacles inside of lower unit. Okay they were in there? How to remove

    1 that cavity should have a drain hole on the lower stbd side of the drive just below the prop shaft
    2 that is a wet area, no concern
    3 barnacles are seen there also. sometimes they clog things...
  7. Re: mercruiser alpha one gen 1 shift problems

    Did you test drive it before purchase? With the drive off is the drives lower shoe in a straight line 12:00?
    Broken lower shift cable
  8. Replies
    2
    Views
    60

    Re: Bellows adhesive?

    3M Weatherstrip adhesive, contact cement , etc
  9. Re: 20 amp breaker blowing on 2006 5.0 mercruiser

    Do you have any other wiring connected to the ign circuit.
    If your a throttle body fuel system remove the flame arrestor and check the wiring for the injectors, chafing there will blow that fuse also
  10. Re: 20 amp breaker blowing on 2006 5.0 mercruiser

    Know of no circuit breakers other than the 50Amp Red button one ,only fuses at the engine ?
  11. Re: Mercruiser 6.2L 350HP bravo 3 - Non DTS - Wont start after shut down during underway

    If you actually got the engine to stop at cruise from an entanglement you most likely have drive damage, possible water up the exaust hydro-lock
  12. Re: GM Hydraulic lifter preload adjustment question

    do each cylinder at a time and you cant go wrong ,rotate untill intake opens and closes , adjust both valves
  13. Re: 1988 Alpha 1 trim manifold leaking water.

    That block is part of the mercathode system, from inside the boat cut the wires, from outside remove the 2 nuts/ bolts and pull down, there are 2 gaskets, 1 under the hyd connection plate and 1...
  14. Re: Merc Catalystt Manifold - Hoist Need? Stuck Rubber Fitting? New O2 Sensors Needed?

    Radio Shack Part Numbers:
    # 2721434 -- 1MFD Cap.
    # 2711356 -- PK5 1MEG 1/4 W
  15. Re: Merc Catalystt Manifold - Hoist Need? Stuck Rubber Fitting? New O2 Sensors Needed?

    I would eliminate the cats with standard manifolds
    Can give better help but need year and engine serial number
  16. Re: Merc Catalystt Manifold - Hoist Need? Stuck Rubber Fitting? New O2 Sensors Needed?

    If you mean the rubber exaust coupling a hook tool works
  17. Re: Aftermarket Serpentine belt - VP 21132390

    Gates for the belt, Dayco for pullys
  18. Replies
    23
    Views
    293

    Re: Engine fails to start (No beep)

    jump the red wire to the yellow/red wire. motor must spin. If not start at the battery terminals
  19. Replies
    23
    Views
    293

    Re: Engine fails to start (No beep)

    When you turn the key to "on"" do the gauges come alive?
    battery switch "on"
    switch in control box is there to prevent starting in gear, not a kill switch
  20. Re: Auction special - 06 bayliner 175 3.0L merc / Alpha 1

    If you in the water :
    By lowering the drive you closed up the main bellow or the shift cable bellow, nothing else
    Inspect caefully, by raising the gimbal housing to its ful upper limit, also watch...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4