Logo

Search:

Type: Posts; User: kelly999

Search: Search took 0.00 seconds.

  1. Replies
    5
    Views
    4,060

    Thanks again for all those thi

    Thanks again for all those things to check out. It'll probably take me most of this week to check them out. I haven't had the carb rebuilt since I've owned it(3yrs). Probably should have it done. ...
  2. Replies
    5
    Views
    4,060

    thanks for those tips. Will c

    thanks for those tips. Will check all filters and check fuel pressure. My manual shows 7-9 psi for pressure.
  3. Replies
    5
    Views
    4,060

    "The motor is the ford 351w wi

    "The motor is the ford 351w with a holley 4 barrel carb. I've done all tune up related maintenance except play too much with the carb. Upon take off there is a slight dead spot around 1000rpms,...
  4. Thread: Oil Type

    by kelly999
    Replies
    2
    Views
    1,163

    thank you very much for the in

    thank you very much for the info.
  5. Thread: Oil Type

    by kelly999
    Replies
    2
    Views
    1,163

    I have a 1976 omc sterndrive t

    I have a 1976 omc sterndrive that is driven by a 351 ford v-8. Am looking to change oil in the engine. I don't have the owners manual. What would be the best weight of oil to use for that engine? ...
  6. Replies
    13
    Views
    9,748

    "I'm not familiar with you

    "I'm not familiar with your 84 model but my old 76 has a seperate motor for the tilt which is located behind the engine on the transom, my trim for the engine is a seperate system. Check to see if...
  7. Replies
    13
    Views
    9,748

    "As you read in my original po

    "As you read in my original post, my armature shaft in the tilt motor was split and I also found out later that I believe the end of my worm gear shaft is slightly damaged as well like it was...
  8. Replies
    13
    Views
    9,748

    "I appreciate your response.

    "I appreciate your response. After some inquiries at my local marine shop, I'm a little confused. I talked to a guy with 30yrs experience in the boating industry and he has only had the tilt clutch...
  9. Replies
    13
    Views
    9,748

    "Hello, have read one of the

    "Hello, have read one of the long threads on this problem and it was very helpful. In any case last year had intermittent tilt problem as took several trys to raise stern sometimes. This spring I...
  10. Replies
    3
    Views
    634

    "Hello, was wondering what is

    "Hello, was wondering what is the best way to to lift the hull off the trailer even just a few inches to replace some cracked rollers on my trailer. The boat is a fiberglass hull, 19ft sterndrive,...
  11. Thread: WOT rpm range

    by kelly999
    Replies
    2
    Views
    803

    thank you very much!!

    thank you very much!!
  12. Thread: WOT rpm range

    by kelly999
    Replies
    2
    Views
    803

    "Hello, I have a 76 Galaxy wi

    "Hello, I have a 76 Galaxy with a ford 351 235hp omc sterndrive. I don't have the owners manual. I am trying to find out what the wot rpm range is for this engine. Anyone know? thanks."
Results 1 to 12 of 12