Logo

Search:

Type: Posts; User: Docksidemarineservices

Page 1 of 4 1 2 3 4

Search: Search took 0.05 seconds.

  1. Re: Mercruiser 5.7, no flow = overheating

    If your elbows are bad, so are your manifolds.
  2. Replies
    2
    Views
    142

    Re: Engine Data Bus Error

    You should start a new thread and post your serial number.
  3. Re: Intermittent power loss on launch/max load

    Post your serial number and take a good picture of the engine and post that too.
  4. Re: Mercruiser 5.7, no flow = overheating

    You don't clean old crappy exhaust. You replace it, or you will be replacing the engine.
  5. Re: Konler generator gas problems

    Clean the fuel supply system, Throw that carb in the garbage can and buy a new one... They are cheap and set up correct right out of the box.
  6. Re: Vovlo Penta engine with a Bravo II outdrive. Ricardo?

    First, the 8.1 is not made by Volvo or Merc. It is a GM engine. We installed complete Merc packages paid for by Volvo... Nothing wrong with the install if they used the red painted engine... With...
  7. Re: MERCATHODE - Bravo3 wires jammed

    FYI, No unusual corrosion, props are not discolored and has not been working for a while? Disconnect the power from the Mercathode generator and Abandon the system...
  8. Re: Sea Star power assist issue

    That noise is associated with pump failure.
  9. Re: Vovlo Penta engine with a Bravo II outdrive. Ricardo?

    Sorry. Going from a Volvo composite to a B2 drive is not a backwards step. Actually that goes for any VP drive.

    FYI Volvo approved the job when threatened by a class action law suit. We have...
  10. Re: MERCATHODE - Bravo3 wires jammed

    Any unusual corrosion or discoloration of the props?
  11. Re: 2006 mercury verado 175 SC fuel problems?

    Follow the directions with the update hose kit. You will need a cup of hot water to soften the hose to install it.
  12. Re: 2006 mercury verado 175 SC fuel problems?

    First, you cannot fix the hose, you have to replace it with the update kit, Second the floats switched in the FSM fail so you should have replaced it... Probably why it is running out of fuel, Third,...
  13. Re: 2006 mercury verado 175 SC fuel problems?

    Pull the FSM and take it apart.. Change the float switch while you are in there.
  14. Re: 2006 mercury verado 175 SC fuel problems?

    The injector is stuck open or the boost reference line in the FSM came off the regulator and is sitting in the fuel, pulling fuel into the intake.

    There is an updated Boost reference hose kit for...
  15. Re: 150 Mercury Verado Intermittent Power Issue When Attempting To Go On Plane

    You have an OPTIMAX, you do not have pencil coils.
  16. Re: No power above idle 2000 Chaparral 252 with 5.7 Mercruiser Bravo III

    Did you check the actual health of the engine? Compression test at minimum.
  17. Re: Mercruser 4.5 Bravo 3 Low Block pressure Alarm

    Fix it the right way. Replace the sensor and retest.
  18. Re: 150 Mercury Verado Intermittent Power Issue When Attempting To Go On Plane

    Start a new thread... Optimax issues are not going to be the same as a Verado issue.
  19. Re: Bravo 0ne drive shaft bearing torque (OL 762931)

    Replace the nut Knock the bearings loose and start over...
  20. Replies
    33
    Views
    415

    Re: 2002 honda outboard woes

    FYI....... I have found on these engines here in NJ.... Where the fuel line, cables, wiring comes through the cowling there is a top clamp that locks everything in place... I have found that this...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4