Logo

Search:

Type: Posts; User: racerone

Page 1 of 4 1 2 3 4

Search: Search took 0.12 seconds.

  1. Replies
    1
    Views
    12

    Re: 96 johnson 90HP

    Have you looked at the water pump impeller ?----Or what happens when your assistant operates the manual pump ?----The VRO operates with pressure pulses from the crankcase , so perhaps there is an...
  2. Re: 1997 Johnson 115hp 2 cycle transom swivel bracket anode location

    So it is a 60 degree looper.----No 433458 as per post # 1 on that motor.------Just looked at a midsection on the scrap pile and that anode is much easier to see with motor off the boat.---- Should be...
  3. Replies
    4
    Views
    26

    Re: 1990 Johnson 115 bogs under load

    I believe post # 2 is very clear !!------But perhaps you are waiting for an answer that you want to hear.------Take the head off now.----There is something wrong with your motor !!----Rebuilding the...
  4. Replies
    4
    Views
    16

    Re: 1987 60 hp johnson with vro

    With 5 wires the VRO was replaced with a newer version.----Powerpack does not plug into the VRO warning module.-----Wires were either cut / hidden or the warning module was never plugged into the...
  5. Replies
    4
    Views
    16

    Re: 1987 60 hp johnson with vro

    Maybe your VRO pump is an earlier model that did not have a warning module !----Model # of your motor ?----pictures of your pump ?----Was your pump disabled already ?----Can you find where the wiring...
  6. Replies
    3
    Views
    39

    Re: Untraceable gremlin

    A motor will run for more than a few seconds on fuel from the carburetor bowl.-----So the carburetor bowl is empty or the high speed jet might be plugged.----The high speed jet ( orifice plug ) is...
  7. Re: Solenoid tests OK but will not energize starter

    The starters really suffered on these motors with broken piston rings.----Folks kept cranking and cranking hoping the motor would start.-------These starters are elegantly easy to take apart for...
  8. Replies
    3
    Views
    22

    Re: 1984 25HP Johnson Evinrude

    With a full carburetor it should run for more than a few seconds !!-----Check the high speed jet.------It is often overlooked and is found way inside the carburetor float bowl.----It is not in the...
  9. Replies
    4
    Views
    10

    Re: PIN-Shift Pivot-With Dri Lok

    It is a Chrysler ( Then called FORCE ) designed lower unit.-------Marketed by Mercury for the last few years.----You might be able to get it back in if the hole on the shifter fork ( 18 ) is in the...
  10. Replies
    4
    Views
    26

    Re: 1990 Johnson 115 bogs under load

    Sorry ----You need to take the cylinder head off on the side with 90 PSI.-----Lucky you if it is just the head gasket blown.-----But I think you will find broken bits of piston rings smashed on the...
  11. Replies
    6
    Views
    28

    Re: 1960 75 hp Johnson seahorse need help

    Post # 1 does not mention that you checked the lower unit for water / oil.----Could be jammed bearings I suppose.----That is why I mentioned it. ---But what do I know.
  12. Re: '93 25HP J25RETS won't idle below 900RPM

    I believe 1/2" is too much.-----Often that is adjusted so there is no clearance by novices.------Best have another look at the carburetor.
  13. Replies
    6
    Views
    28

    Re: 1960 75 hp Johnson seahorse need help

    Remove the gearcase ( lower unit ) in case that is binding up.------Smooth running motor when in good condition.------A bit thirsty on fuel by the standards of today.
  14. Re: '93 25HP J25RETS won't idle below 900RPM

    It is usually not touching at idle.----Try giving that stop 3/16" clearance.----Oh --It cost no coins and very little effort to try that.--------One of those adjustments on an outboard that looks...
  15. Re: '93 25HP J25RETS won't idle below 900RPM

    Facts for you.------I do believe it is running too lean.-----Is the throttle plate fully closed at idle ?----It must be !----Post a video showing the stop on that thin rod that goes to the back of...
  16. Replies
    3
    Views
    39

    Re: Untraceable gremlin

    Does spark jump a gap of 5/16", yes or no ?----If you have gone over the carburetor 4 times I would say it is NOT a fuel problem.
  17. Re: 1997 Johnson 115hp 2 cycle transom swivel bracket anode location

    I think there are 2 anodes (433458 ) one on the bottom of each bracket.
  18. Re: 1997 Johnson 115hp 2 cycle transom swivel bracket anode location

    Model # of your motor ?-----There are 2 different 115 HP motors in 1997 !
  19. Re: Year of my Mercury outboard please help

    I can only guess that it is a 1990 model.-----Most real MERCURY dealers will want that serial # to get you the correct parts !!
  20. Replies
    7
    Views
    32

    Re: 1980 Evinrude 115

    If you can solve it with money there are no problems.-------Myself I would test the starter !!!----Then perhaps a new set of brushes ( $6.00 ) from auto electric store.
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4