Logo

Search:

Type: Posts; User: blackbetty

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    304

    looks like '84 and '85

    looks like '84 and '85 are the same
  2. 1981

    1981
  3. Replies
    13
    Views
    1,739

    "type the link to the pic. c

    "type the link to the pic.
    could be the CDI, try using the plug you know fires in the other boot. perhaps the non-firing plug is bad, (one could only hope its that easy). CDI is hard to test w/o...
  4. Replies
    1
    Views
    553

    "I've never bought a new m

    "I've never bought a new motor straight from the factory, cant afford it, and frankly some last forever, some have issues out of the box. Read the forum for a while and you will see for yourself. I...
  5. Replies
    13
    Views
    1,739

    hard to help w/o #s

    hard to help w/o #s
  6. Replies
    3
    Views
    6,755

    "It all comes down to fuel, sp

    "It all comes down to fuel, spark and air, and of course a little english.http://www.marineengine.com/discus/clipart/lol.gif"
  7. Thread: Tune up

    by blackbetty
    Replies
    1
    Views
    5,884

    "I normally do my own maintani

    "I normally do my own maintaniance (plugs, lower unit oil etc) but this year I am thinking of sending it to a service tech to go over it with a fine tooth comb. I have a 86 DT25. It runs great, only...
  8. Replies
    4
    Views
    1,226

    "I'm not a mechanic, but s

    "I'm not a mechanic, but shearing the key would certainly mess up timing. Are you getting spark at the plugs? If so, the timing is probably off. I would think if it was a crank issue you would hear...
  9. Replies
    7
    Views
    4,321

    CDI or ignition timing switch

    CDI or ignition timing switch is the likely culprit
  10. Replies
    5
    Views
    6,694

    "[url=""]http://store.brownspo

    "http://store.brownspoint.com/dt4.asp

    Looks like an 88 to me"
  11. Replies
    10
    Views
    1,962

    "i would imagine you could get

    "i would imagine you could get a new switch from aftermarket, wire it up and install in the control box, but then again, i'm not a mechanic and do not know if your machine requires special equipment....
  12. Replies
    7
    Views
    949

    I have been putting my leftove

    I have been putting my leftover mixed gas in my SUV for years without screwing things up in my car. I just put in 2-3 gals mixed per full tank of regular gas until this mixed is gone. the ratio of...
  13. Replies
    4
    Views
    1,158

    "First off, I am not a mechani

    "First off, I am not a mechanic, more of a broke do-it-yourselfer, so this is not professional advice, just my experience I had with an 86 DT25 with a similar problem. I donít know if there are...
  14. Replies
    2
    Views
    1,398

    "I have been using 100-1 for y

    "I have been using 100-1 for years in my DT25. When i bought the motor, i was told to do 100-1. I thought it was a light mix. I was told Suzuki is one of the few motors that can handle the lean mix...
  15. Thread: New to site

    by blackbetty
    Replies
    3
    Views
    616

    "Just want to say that you guy

    "Just want to say that you guys are running a great forum here. Lots of help for the do-it-yourselfer. Its good to see people share information with each other instead of relying on a service rep at...
  16. Replies
    0
    Views
    454

    "Just want to say that you guy

    "Just want to say that you guys are running a great forum here. Lots of help for the do-it-yourselfer. Its good to see people share information with each other instead of relying on a service rep at...
  17. Replies
    0
    Views
    555

    "I need to replace the ignitio

    "I need to replace the ignition timing switch on my '86 DT25. The original part #32150-96310 has been replaced with 32150-96313. The replacement part has 2 wires, 1 red/white and 1 black. The...
Results 1 to 17 of 17