Logo

Search:

Type: Posts; User: Abehr

Search: Search took 0.00 seconds.

  1. Replies
    10
    Views
    383

    Re: 2006 60 HP EFI Stalls When Cold

    Resolved after plugs, both filters, new IAF, new temp sensor, and fresh gas with injector cleaner.
  2. Replies
    0
    Views
    495

    Mercury Temp Sensors

    Can anybody tell me if the temp sensor in this kit #56-820386A76
    http://www.marineengine.com/boat-forum/blob:http://www.marineengine.com/1b8d3a4c-1607-497b-8baf-3c355fc78480

    is the same as...
  3. Replies
    10
    Views
    383

    Re: 2006 60 HP EFI Stalls When Cold

    Plugs were gapped incorrectly. Idles fine now, but will stall at high RPM and when throttling down.
  4. Replies
    10
    Views
    383

    Re: 2006 60 HP EFI Stalls When Cold

    Installed a new IAC and fresh plugs gapped to spec and now it runs even worse. Now it stalls just about every time coming out of gear and idles rough.
  5. Replies
    10
    Views
    383

    Re: 2006 60 HP EFI Stalls When Cold

    Do you know if this modelís IAC is serviceable? Would you trust a used IAC?
  6. Replies
    10
    Views
    383

    Re: 2006 60 HP EFI Stalls When Cold

    Update: new filters and fresh fuel with injector cleaner has not helped.

    After really examining the motor I found a slight leak coming from the air intake. The motor is also slowly surging a...
  7. Replies
    10
    Views
    383

    Re: 2006 60 HP EFI Stalls When Cold

    Update: replaced the low pressure filter and found the filter to be pretty dirty and a good bit of old fuel crystals at the bottom of the bowl.

    I also replaced the fuel line and primer bulb...
  8. Replies
    1
    Views
    96

    Re: Merc 60 EFI bottom cowl removal

    I was able to push #5 out of the way just enough to get a ratchet on it
  9. Replies
    1
    Views
    96

    Merc 60 EFI bottom cowl removal

    Can anybody tell me how to remove the bottom cowl on my 06 60 EFI? I canít seem to get access to the top front bolt where the fuel line comes in. (#3 bolt next to #5 in the diagram)

    23295
  10. Replies
    10
    Views
    383

    Re: 2006 60 HP EFI Stalls When Cold

    It’s serial number 1B250285. I found what might be a small leak coming from between the low pressure pump and the head. Just a little bit of moisture on the head under the pump. Could this be the...
  11. Replies
    10
    Views
    383

    2006 60 HP EFI Stalls When Cold

    So my 2006 Merc 60 EFI has been giving me issues lately. Whenever itís first put in the water for the day itíll often stall immediately when put into gear or after given throttle in gear. It will do...
Results 1 to 11 of 11