Logo

Search:

Type: Posts; User: makomark

Page 1 of 4 1 2 3 4

Search: Search took 0.05 seconds; generated 44 minute(s) ago.

  1. Replies
    2
    Views
    56

    Re: No forward only reverse

    Your description lacks some details....based on what is there, have you checked the propeller's hub?
  2. Replies
    8
    Views
    120

    Re: Won't Start, turnsover

    could be the coil but I would verify the primary system is pulsing....last time I checked, those coils were EXPENSIVE....

    On the wires, with low usage and proper installation, I'd think you should...
  3. Replies
    8
    Views
    120

    Re: Won't Start, turnsover

    use the tester on the coil...if that works, sounds like a cap or rotor...pretty sure you have the HVS 'crab cap'...and they are known to have finite lifetimes...if you replace it, use one of the OEM...
  4. Re: 1986 Crusader 454 electronic ignition conversion problem

    If the EST is connected to an ECU, then the ECU will 'optimize' the timing continuously...
  5. Replies
    9
    Views
    399

    Re: Chrysler 426 Exhaust over heating

    warmer at idle could be a small restriction or the pump being marginal at low speed...

    based on the plumbing diagram, the exhaust manifold will likely be 'cold'....I'd say it may see up to a 25-30...
  6. Re: 1986 Crusader 454 electronic ignition conversion problem

    The ESTs, in stand alone mode, have a very steep timing curve and exhibit similar behavior at idle and off idle...
  7. Re: Crusader 454 xli no fuel pump power - looking for some diagnostic help

    the ECU uses the presence of reference pulses from the distributor to enable the fuel pump...

    if you jump the relay (what you are calling the pink wires) and the pump doesn't run, sounds like the...
  8. Re: Crusader 454 xli no fuel pump power - looking for some diagnostic help

    the circuit doesn't work like that....
  9. Re: 4.3 MPI Diagnostic Readings for no start

    If the scanner is talking to the ECU, the main relay is engaged...

    the only things in your list that I see is the battery is low...may need cables cleaned or a good charge.

    if you have fuel in...
  10. Re: Boat runs then stalls underway, then starts right up

    you can use the iridium plugs...and they should last for years...

    For the boots, they make pliers for that purpose...i usually twist the boots to break them free from the plug's ceramic before...
  11. Re: Boat runs then stalls underway, then starts right up

    If you use the boat with some regularity, using the platinum tipped spark plugs can help extend the maintenance intervals....Caps usually last a few seasons but your history is the best source...
  12. Re: Boat runs then stalls underway, then starts right up

    Check the fuel pressure...it has to be consistent under load as well as at idle...

    a Scan tool to check for codes and verify sensor inputs is another good step...
  13. Re: Boat runs then stalls underway, then starts right up

    pretty sure that's a 555 ECU...I'm pretty certain there is no oil pressure switch controlling the fuel pump on that configuration.
  14. Re: Boat runs then stalls underway, then starts right up

    thats a SENSOR, not a switch...

    Does that engine the the 555 ECU on it?
  15. Re: Crusader 454 xli no fuel pump power - looking for some diagnostic help

    you won't see any fuel pump related codes with the MEFI-2....

    Jumping the green/white to ground was not a good thing to do as that could have shorted out the fuel pump driver circuit in the ECU......
  16. Re: Mercruiser 7.4 L Mpi L29 MISS FIRING in Bayliner 2855 Cierra

    the injectors are controlled as two banks of four...within a given bank, two will be on one head and two will be on the other head...i don't see how an electrical problem screws up all four injectors...
  17. Re: Boat runs then stalls underway, then starts right up

    the part you listed is a sending unit, not a switch...

    I'd be inclined to check for fuel pressure (or lack there of) as a first step...
  18. Replies
    7
    Views
    216

    Re: 1998 Crusader 454 XLi dies after running

    make any progress?
  19. Re: Crusader 454XL-TB Starting/running problem

    glad you resolved this one....what part number did Carter suggest?
  20. Replies
    1
    Views
    77

    Re: 45# trolling motor

    It may be undersized...if possible, check with the boat manufacturer to see what trolling motor(s) they offered the boat with...a dealer for that brand would be another option...that would likely be...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4