Logo

Search:

Type: Posts; User: bondo

Page 1 of 4 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    3
    Views
    50

    Re: Alpha 1 generation?

    Ayuh,.... Gen.IIs came out in '91,....
  2. Re: BF250A Throttle Actuator wiring harness mis-matched

    Ayuh,..... Patience, 'n a multimeter, 'n you should be able to figure out which wire goes where,....
  3. Replies
    6
    Views
    143

    Re: Remove/Bypass Heat Exhanger

    Ayuh,..... There's some different parts involved,.... T-stat housin' for one,...
  4. Thread: Mystery Bolt!?

    by bondo
    Replies
    8
    Views
    90

    Re: Mystery Bolt!?

    Ayuh,.... Check all the flywheel cover to the block bolts,....
  5. Re: Mercury 4.3 alpha 1 drive stalls during excelleratipn

    Ayuh,.... Try goin' to the richer hole on the rod,....
  6. Replies
    2
    Views
    61

    Re: 1987 Sunrunner VP DP 290?

    Ayuh,..... The earlier motor is a 2 pc. rear main, 'n the later is a 1 pc. so there maybe fitment issues,....

    '86 is the year of the change,....
  7. Replies
    8
    Views
    146

    Re: 1991 Four Winns 285 Water Pump Problem

    Ayuh,..... If yer backin' in deep enough to totally submerge the drive, it shouldn't need to be primed, as the pump will already be flooded,......

    These pump will Not suck water, they're...
  8. Re: 05 GM 3.0 Alpha one intake manifold stud thread

    Ayuh,.... The studs are fine thread on one end, 'n course on the other,.....
    I believe the course threads are into the head/ manifold, so the carb nuts should be fine thread, 5/16" - 24, I...
  9. Thread: Steering

    by bondo
    Replies
    4
    Views
    521

    Re: Steering

    So, yer postin' in an 11 year old thread, to push yer product,..??

    I think that's called Spammin',..... :rolleyes:

    As for My post,...... 'bout the Best cure for V-hull wander, is in...
  10. Replies
    8
    Views
    146

    Re: 1991 Four Winns 285 Water Pump Problem

    Ayuh,..... How are you supplying water to it,..??
  11. Thread: 2000 5.0 merc

    by bondo
    Replies
    2
    Views
    110

    Re: 2000 5.0 merc

    Ayuh,..... Either a blockage, or vacuum leak, upstream of the filter,.....
  12. Thread: 5.7 Timing

    by bondo
    Replies
    9
    Views
    223

    Re: 5.7 Timing

    Ayuh,..... Then you did something wrong there,.....

    Backfires through the carb, is a classic symptom of a lean condition,.....
  13. Replies
    2
    Views
    144

    Re: 1990 Bayliner capri statar and power pack

    You need the Chrysler Outboard forum,....
  14. Replies
    2
    Views
    144

    Re: 1990 Bayliner capri statar and power pack

    Ayuh,...... Donno why you posted in the Chrysler I/O forum, as Chrysler was outa the marine power business long before 1990,.....

    So, what motor/ drive do you have,..??
  15. Replies
    1
    Views
    99

    Re: Dory 13 auxiliary bracket help

    Ayuh,.... You don't have boat enough,....

    Spend yer time, 'n resources on makin' yer motor, Reliable,....
  16. Replies
    2
    Views
    189

    Re: Reconditioning vintage gas tank

    Ayuh,..... That's the one good thing ethanol is great for,.... dissolving old gas deposits,....

    I've done this with a handful of nuts/ bolts, 'n dump the residue into waste oil containers,....
  17. Thread: Gasket failed

    by bondo
    Replies
    1
    Views
    100

    Re: Gasket failed

    Ayuh,..... That's yer dice to roll,...... You over-tighten the bolts, which ripped the gasket,....
  18. Replies
    3
    Views
    160

    Re: what's that awful clanging noise?

    Ayuh,..... There's 8 nuts, 'n the drive is off,...... weighs 'bout 80 lbs,.... no need to drain it,....
    You can feed water through the hole in the gimbel, by crammin' a hose into it,... I...
  19. Re: Honda 8 Hp, has anyone installed a tilt trim switch

    Ayuh,.... Ya need a 3 position momentary toggle switch, powered the center terminal, blue/ up wire on the lower terminal, 'n the green to the other terminal, 'n mount the switch where ever ya want...
  20. Re: Honda 8 Hp, has anyone installed a tilt trim switch

    Ayuh,..... An 8 hp, with hyd. trim, 'n tilt,..??..??
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4