Logo

Search:

Type: Posts; User: faztbullet

Page 1 of 4 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    7
    Views
    61

    Re: Water in lower unit

    Make sure bearings and shafts are ok or seal kit wont help anything....
  2. Re: Motor Runs on Hose but Won't Start on Lake

    If starter is weak it cannot spin fast enough against backpressure..thru weak or no spark.
  3. Replies
    3
    Views
    43

    Re: Johnson Ficht Diagnostic software

    You can ohm ohm out cable ....need a puter expert to see if can get software to work with Win10. I am in search of a old laptop with Win7 to reinstall my software on as know it does work with 7
  4. Re: Gearcase "tailfin" - no oficial part number

    Here....
    Amazon.com: Mercury/Mariner Outboard Skeg 40-70 Hp Straight Back WSM SK-2: Automotive

    https://images-na.ssl-images-amazon.com/images/I/41mUGAk45WL._AC_SX425_.jpg
  5. Thread: Stator Test

    by faztbullet
    Replies
    5
    Views
    64

    Re: Stator Test

    Has it had the rectifier kit installed?....893640A02
    ...
  6. Re: 2003 evinrude ficht 200 bearing carrier replacement

    Rear thrust washer/bearing holding it from seating
  7. Replies
    17
    Views
    147

    Re: 1978 Evinrude 70HP woes

    This was the suggestion to keep you out of rabbit hole........Good luck figuring it out.
  8. Replies
    5
    Views
    82

    Re: Is it electrical or fuel

    The temp sensor is throwing pack into SLOW. When you turn off and restart it is reset. A weak impeller or sensor will cause this.
  9. Re: 1998 Johnson 175 Ficht won't get out of the hole

    A lot of software quit on the last Win10 update. My laptop with dongle to change water mixing valves quit and now have to up date driver boards in mixer to WiFi ($8K)
  10. Replies
    11
    Views
    79

    Re: Power coil issues 1998 Evinrude 60hp

    Are you testing with everyday ohm/voltmeter or CD-77?( not many people own these)
  11. Replies
    17
    Views
    147

    Re: 1978 Evinrude 70HP woes

    Leave reeds alone ....aint yer problem
  12. Re: 1998 Johnson 175 Ficht won't get out of the hole

    Time to find someone with computer and software to see what codes are thrown.
  13. Replies
    5
    Views
    82

    Re: Is it electrical or fuel

    Replace impeller
  14. Replies
    11
    Views
    79

    Re: Power coil issues 1998 Evinrude 60hp

    Sound like a Seloc POS manual.....if you are cranking the motor with test lead in any of the browns and other to ground there will be voltage reading.
  15. Replies
    20
    Views
    194

    Re: 95 evinrude 200, spark timing way off

    Not quite....can lose individual cylinders
  16. Replies
    3
    Views
    57

    Re: Johnson 115 V4 Rebuild

    Replace all 4 piston or it will happen again, make sure you repair cylinder wall by boring.
  17. Re: Evinrude 70HP 1984 3Cyl 2stroke Rev RPM problems

    Leave the stock ones in...the Boyesen will last about 2 years and you have to re jet idle.
  18. Replies
    2
    Views
    46

    Re: Johnson 35 Hp 1982 Backfires

    Check ignition wires..make sure not flipped
  19. Re: 1995 130HP Johnson V4 (2 stroke) different kind of regulator?

    Flywheel....35 amp was a option and has vents, the 10 amp is solid. Change water pump as that and battery connections kill water cooled rectifiers
  20. Replies
    8
    Views
    101

    Re: 1987 Johnson 90hp clean spark plug

    Head gasket or reed
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4