Logo

Search:

Type: Posts; User: pvanv

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    8
    Views
    45

    Re: Tohatsu TLDI 90 -06 problems

    If you are dumping way too much oil, you could be fouling plugs and idling too low...
  2. Replies
    4
    Views
    20

    Re: 2017 25 hp won't start with key

    OK, so MFS25 B or C. Could be bad ground, bad wiring to the control box, bad key switch, bad solenoid, or bad starter. What happens if you jump the solenoid?
  3. Replies
    8
    Views
    45

    Re: Tohatsu TLDI 90 -06 problems

    I am certified on TLDI, but it's difficult to dx on a forum. Not sure about Finland, but many dealers in the US. The codes are similar on all TLDI, you you may be over oiling, and may have other...
  4. Replies
    4
    Views
    20

    Re: 2017 25 hp won't start with key

    What make and model? Year is irrelevant. Could be bad wiring to the start side of the key, bad solenoid, bad starter motor...
  5. Replies
    8
    Views
    45

    Re: Tohatsu TLDI 90 -06 problems

    I would go to Tohatsu.com and check the dealer locator. With your issues, someone knowledgeable should probably look at it.
  6. Replies
    6
    Views
    41

    Re: Tohatsu/Mariner 30 2 stroke charging coil

    what connectors does the regulator have? Is there a spare capped off wire on the CD?
  7. Replies
    8
    Views
    45

    Re: Tohatsu TLDI 90 -06 problems

    Do you have a dealer near you?
  8. Replies
    2
    Views
    23

    Re: 1998 Nissan NSF5A Long Shaft

    push the cam rod down to neutral.
    BTW... never do the impeller. Do a complete wp kit.
  9. Replies
    1
    Views
    25

    Re: Restrictor removal

    No. The 9.8 is carbed. The 9.9/15/20E requires that the ECU match the flow restrictor.
  10. Replies
    6
    Views
    41

    Re: Tohatsu/Mariner 30 2 stroke charging coil

    The alternator coil should only have 2 wires. If the black has aring terminal, it's ground.
    The alternator is pretty puny, and the battery is big. A fully charged wet cell isn't 12v but rather about...
  11. Replies
    6
    Views
    41

    Re: Tohatsu/Mariner 30 2 stroke charging coil

    You will also need a rectifier/regulator.
  12. Replies
    2
    Views
    31

    Re: 1986 Nissan 70 HP Tilt Locked

    Year is irrelevant. What is your actual model? Is it power tilt? If not, there is a lock lever on the port side of the transom bracket.
    If power tilt, there is a release screw on the pump. You can...
  13. Re: Has Tohatsu stopped making 9.8 XLS remote models

    The XL sailpro is now available in the 9.9EFI. You can also retrofit a 9.8 with a longer driveshaft, water tube, and the spacer if you must have the 9.8
  14. Replies
    1
    Views
    32

    Re: NS5B re attaching lower unit

    First, always do a complete wp kit; not just the impeller. Lasts longer and pumps better.
    You are not engaged correctly; you may have the water tube striking the wp housing. Drop it again, make sure...
  15. Replies
    2
    Views
    55

    Re: 2007 8hp 4 stroke tohatsu

    3V2675010M
    SEAL RUBBER, TOP COWL (L=1295mm/50.9")
    $52.55



    /*also need 3AA671201M, if replacing older style cowl seal (3V1)-PARTS BULLETIN 12-006*/
  16. Replies
    3
    Views
    81

    Re: '84 NS 50B Trim Motor Shorted Out?

    I think something may be wired wrong. Odds are your motor only has 2 wires; The up and down solenoids reverse the DC polarity to the motor.
  17. Re: Nissan 4-stroke 6HP (NSF6BS) Water/Exhaust Question

    Definitely tine for a new cup. Sometimes they are quite stuck. When installing, I usually use grease or antiseize so that isn't a factor next time. You can warm the housing with a heat lamp....
  18. Replies
    1
    Views
    57

    Re: Odd Discoloration On Connecting Rod

    Looks like Factory conn rod balancing to me.
  19. Replies
    3
    Views
    81

    Re: '84 NS 50B Trim Motor Shorted Out?

    Strange. There's only UP, Down, and ground. You could take it to a local 12v auto electric shop.
  20. Replies
    1
    Views
    99

    Re: Tohatsu 3.5 leaking fuel

    Likely the carb is flooding. The needle and seat should be cleaned and or replaced.
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4