Anybody know the size of the flange nut. Is it 1&7/16? Thanks

1976 silverten borg warner velvet trans and v drive its all one unit. Has ony one change the prop shaft flange seal.l think i canget the sfaft back enough to get at that big nut.any helpwould be...

36 to 72 inch lbs

Anyone know the torque spec thanks

ok thanks

1976 28 ft silverton with 2 crusaders 5.0 replacing shift cables 2 do the universal cables work ? J am changing ables from down stair helm these are factory controls not sure about cables has...

any body around Barnegat bay had power washed for winter they always do a good job.this time it looks like a leopard spots.checked a few other boats at marina the have them too.their smooth from the...

is any body using the complete after market kit .with every thing new just hook up 2or 3 wires and set base timing. i have used the gm ones they work great.or trouble check this system? thanks

ok ill try it thanks

this maybe crazy i changed float switch with a rule same as i had before. i think with the old switch it would come on and pump out.as the float hit the bottom.it seemed to run for a few seconds.this...

Thanks

1996 silverton 31ft 454 mercs v drives what trans is most popular?tanks

Thanks

Faceing the bow of the boat standing behind the engine where is number one port or starbord top or bottom? I downloaded mznual gives cireing order but not positionof number 1 cylthanks

thanks gu7ys

1976 26 ft silverton ac shore power .when plugged in in live state that i no should not be done but if done while plugging in i hear a buzzer? i looked under deck seems to be some type of box like a...

late reply followed video cut out section re did it all over. came out good.cost 400.00$material thanks for replys

Sorry to get back so late bt righr on. Gray wire to tbi was rubing hat on blows fuse hat off ran good. Fixed gray wire back in shape thanks for comebacksbcc lew

mercruiser1998 5.7 tbi I had another post on having a bad fuel injector same engine. new prob engine run fine starting it and let it mabe 5 mins. or even 20 mins then blows ing. relay fuse15 amp and...

update 7/24/20 bought a gm est distributor kit from united marine engine parts. hardest part making a bracket for the coil.3 hour job not to bad runs fine thanks for all the input bcclew