Logo

Search:

Type: Posts; User: faztbullet

Page 1 of 4 1 2 3 4

Search: Search took 0.03 seconds.

  1. Re: Mariner 9.9 controls on Merc 25 tiller motor?!

    The Merc tiller if OEM shifts thru the tiller handle. If OEM you will need to find remote cable support bracket and linkages to allow remote shifting/throttle. If it was a remote coverted to tiller...
  2. Re: 97 Merc 90elpto Weak Spark all plugs

    Why did you replace all this? Have you tested DVA output as ohms test is not trusted in my book. Seen to many parts pass OHM spec and still be bad...
  3. Re: 97 Merc 90elpto Weak Spark all plugs

    Why did you replace all this? What problems are you having?
  4. Replies
    4
    Views
    24

    Re: 1976 85 HP Evinrude Water Pump Help

    That the seal and it goes under metal cover with the 2 slotted screws and guides..
  5. Replies
    14
    Views
    102

    Re: 85 mercury black max 150 throttle

    Engine side ................................Controller side
    Red................................................red
    Black..............................................black...
  6. Re: mariner magnum 150 water in #6 cylinder

    Why was it rebuilt? Was #5 or 6 damaged?
  7. Replies
    4
    Views
    24

    Re: 1976 85 HP Evinrude Water Pump Help

    Your model does not use a gasket under wear plate, the o-ring goes in groove on top of driveshaft and seal
  8. Replies
    8
    Views
    102

    Re: Lightweight V6 and V8

    If you just want lightest power head......... the 60 150-175hp and the 200-225 Merc chrome and Nic motors
  9. Re: 2002 225 mercury 225 optimax oil question

    Only use oil stated for DFI engines...
  10. Replies
    13
    Views
    109

    Re: Evinrude 115hp

    go here...
    https://www.outboardignition.com/page40.asp
  11. Replies
    8
    Views
    102

    Re: Lightweight V6 and V8

    Your are correct as I didn't check my typing..should have been 375Lbs
  12. Replies
    8
    Views
    102

    Re: Lightweight V6 and V8

    Lightest V6 is the 60 Johnrudes at around 275Lbs The OX series is around 450Lbs
  13. Replies
    13
    Views
    109

    Re: Evinrude 115hp

    No as stator has a charge coil for each pack(brown wires)..You want to see 150+V at cranking on these wires.
  14. Re: 1999 Johnson 50 inconsistently running poorly

    Both of you need to go thru the carbs and also check fuel supply line for internal liner failing.
  15. Replies
    5
    Views
    66

    Re: 70hp elcim stator question?

    Will spark jump a 3/8 air gap? The black stuff is usually a stator melting down due to bad rectifier...
  16. Replies
    7
    Views
    95

    Re: performance vent plugs

    Depends on the boat...start off with all solid and work way up till find best holeshot with max load.
  17. Thread: e115tlcte

    by faztbullet
    Replies
    1
    Views
    41

    Re: e115tlcte

    Ql78jc4 @.030
  18. Replies
    13
    Views
    109

    Re: Evinrude 115hp

    That wont cause it to have no spark..just to wrong cylinder. No spark on a bank is either: no output from stator to pack on that side,timer base output on that side, or pack
  19. Replies
    4
    Views
    59

    Re: 1998 50spl J50TSLECC

    Unplug the temp wire from power pack and retest...its the tan single wire from pack.
  20. Re: Installing Evinrude 85 h.p. Outboard on Bayliner Capri.

    You just need these.....
    https://www.marineengine.com/newparts/part_search.php?part_num=CA27321P
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4