Logo

Search:

Type: Posts; User: RobertFL

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    118

    Re: 1998 BF90 Hydraulic Tilt not working

    My 1998 BF90A Trim n Tilt worked well but sometimes would hang up at full tilt, I would have to open the manual screw to drop it, then it was fine until I raised it fully again.. I think it may of...
  2. Replies
    2
    Views
    118

    Re: 1998 BF90 Hydraulic Tilt not working

    no expert myself...but maybe you have an internal valve problem? Also you may have to run a few more up/down cycles to work more air out of fluid, run a few cycles, fill with fluid, let it sit an...
  3. Re: BF40 idling issues, opened it up, discovered this...

    Glad you got some good info and a easy fix..I was not sure if you had to use a special grease on the push rod or special anti seize on the bolts... I would order a new "O" ring along with the pump,...
  4. Re: BF40 idling issues, opened it up, discovered this...

    Chunchy, No screens on mine just an inline filter just before the fuel pumps. I installed a water separator type fuel filter onto the transom between the engine and fuel tank.
  5. Re: BF40 idling issues, opened it up, discovered this...

    Texas, It looks like an easy fix, having never replaced one there may be a trick or two.. some research might be needed . Since my engine has 2005 hours on it I will be replacing the fuel pump "push...
  6. Re: BF40 idling issues, opened it up, discovered this...

    Thats the fuel pump. As far as I know there are no rebuild or gasket kits available. I have a 1997 BF90a that has 2 fuel pumps and one just started a small drip also. I have to buy a new fuel pump or...
  7. Replies
    3
    Views
    185

    Re: 1997 BF90 lower unit seal kit options

    I bought a boat last year with a 1997 BF90A and am slowly working on it, engine is good but am working on the boat itself. My lower is Mercury....
Results 1 to 7 of 7