Logo

Search:

Type: Posts; User: bondo

Page 1 of 4 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    10
    Views
    107

    Re: Draining bilge often while on the water?

    Ayuh,.... The only way to find a leak, is to Look for it,.....
  2. Re: Oil Leak 1985 MCM 228 after stringers collapsed

    Ayuh,.... They tend to rust through, the collapse may have breached a bad spot,....

    The crank couldn't shift enough to cause the rear main to leak,....
  3. Replies
    3
    Views
    78

    Re: Upgrade an oldl B2 to a B3 duoprop

    Ayuh,.... That should work out just fine on a 25' boat,....
  4. Replies
    12
    Views
    183

    Re: Test Run 4.3 Mercruiser on stand

    Ayuh,.... That's Ok, it's completely understandable,....
    'n I agree, alligator clips,. directly to the components is also how I test run motors,....
  5. Re: Left my ignition on for a couple days now I get no spark

    Ayuh,..... Start there,.....
  6. Re: Oil Leak 1985 MCM 228 after stringers collapsed

    Ayuh,..... I'd suspect possible oil pan damage, rather than the rear main seal,.....
  7. Replies
    26
    Views
    307

    Re: 5.7 reman mystery....

    Ayuh,..... Has anybody inspected the Contents of the fuel filter,..??

    Water in the fuel, will also cause detonation,.....
  8. Replies
    26
    Views
    307

    Re: 5.7 reman mystery....

    Ayuh,..... Is this a carbed motor,..??

    Detonation will do that sorta thing, easily in 100 hrs,.....
    Probably tuliped the valve is where the compression went,..... Pressurize that cylinder...
  9. Replies
    2
    Views
    122

    Re: Replace drive plates?

    Ayuh,..... If not lubed, the splines can wear,.....

    If the splines are still good, reuse 'em, with abit of grease of course,....
  10. Replies
    2
    Views
    93

    Re: Help on removal of throttle handle

    Ayuh,..... There's bazillions of controllers, 'n we can't see what yer seein',.....
  11. Thread: OMC Seized?

    by bondo
    Replies
    4
    Views
    94

    Re: OMC Seized?

    Ayuh,..... They're splined together, split the motor off the drive,.....
  12. Replies
    2
    Views
    54

    Re: Disintegrated Gimbal Bearing!

    Ayuh,..... You can either rig a slide hammer puller to it, or pull the motor, 'n beat it out from the inside,.....
  13. Thread: OMC Seized?

    by bondo
    Replies
    4
    Views
    94

    Re: OMC Seized?

    Ayuh,...... Pull 'em, 'n separate 'em,.....
  14. Re: Replacing a points distributor for electronic

    Ayuh,..... Look into the Delco EST ignition,....

    Merc, 'n Volvo use it as oem on some of their motors,....
    Quality stuff at reasonable prices,.....
  15. Replies
    4
    Views
    205

    Re: What trailer brand is this?

    Ayuh,..... Then I'd just call it "Homemade", 'n move on,.....
  16. Replies
    17
    Views
    278

    Re: 98 Mercruiser 5.7 manifolds different temps?

    Ayuh,..... Manifolds rarely to never run the exact same temps,.....
  17. Replies
    4
    Views
    205

    Re: What trailer brand is this?

    Donno,.... What does it's paperwork say it is,..??..??
  18. Thread: Wire Connectors

    by bondo
    Replies
    2
    Views
    119

    Re: Wire Connectors

    Ayuh,.... I believe female bullet connectors will slip on those posts, 'n stay put,.....

    28495
  19. Re: 2004 crusader 6.0l gas engine in carver 360 mariner

    Ayuh,..... Not havin' a scan tool, I check the Contents of the fuel filter for anything but clean fresh gasoline 1st,.....

    If that checks out, Then I call a bud, with a scan tool,.....
  20. Thread: Side Panels

    by bondo
    Replies
    4
    Views
    142

    Re: Side Panels

    Ayuh,..... Generally speaking, the fasteners are hidden by snaps 'n trim pieces,....
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4