MarineEngine.com - Your online store for all types of marine engines and boat parts.
PHONE ORDERS
Monday - Friday
9:00 AM - 5:00 PM EST
Click for TOLL-FREE Number
Online Checkout
Special $9.95 Flat Rate Shipping
(800) 209-9624 | Home | Contact | Shipping | Returns | Cart View your shopping cart.
Part Number Search
Shop by engine/drive part number.
Original & matching parts for sale.
Manuals & Accessories
Shop by description, item number
or manufacturer's model number.
Boat Repair Forum Boat Repair Forum   Boat Video Gallery Video Gallery
   

Search:

Type: Posts; User: dark_star

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    4
    Views
    120

    Re: Engine Cowling Causes Stall

    I had this problem on a BF8A , would run fine with the hood off but within minutes of putting it
    back it would stall.
    turned out to be a cracked exhaust tube which was allowing exhaust gases into...
  2. Replies
    11
    Views
    421

    Re: Discharge from "pee hole"

    Thanks for that Mike !
  3. Replies
    11
    Views
    421

    Re: Discharge from "pee hole"

    Does anybody have the Honda part number for this fitting ?
  4. Replies
    11
    Views
    421

    Re: Discharge from "pee hole"

    Yes, there is another thread which covers it.
    will see if I can find it
  5. Replies
    7
    Views
    167

    Re: bf50a power trim

    Thanks for the help all !
  6. Replies
    7
    Views
    167

    Re: bf50a power trim

    It was a loose ground wire....
  7. Replies
    7
    Views
    167

    Re: bf50a power trim

    Motor starts up fine, neither the remote switch nor the engine mounted switch will operate the tilt trim now.
    There is power going to the unit, but I think there most be a corroded wire or...
  8. Replies
    7
    Views
    167

    bf50a power trim

    1999 BF50A
    Sometimes when the motor is at idle or stopped and you hit the trim switch
    all you get is an electrical squeal. (no lift)
    When engine is powered up the trim switch seems to activate...
  9. Replies
    5
    Views
    977

    Re: BF50 Honda ~ beeps when throttled up

    I had the same problem, disconnected the trim sensor and it stopped.
    don't really know why you need this feature anyway ?
  10. Replies
    5
    Views
    160

    Re: 2001 90 hp 4 stroke problem

    Your thermostats might be corroded with salt.
    suggest open it up and replace them to begin with.
    do you flush with fresh water ?
  11. Re: Do I need "marine oil" or is this oil ok for my Honda BF30...

    I think Tohatsu Guru explained it in great detail, after reading the thread I would not use synthetic in my outboard.
  12. Replies
    7
    Views
    153

    Re: Honda outboard BF30A only goes 17mph...

    what kind of rpm's are you getting at WOT ?
    this will help determine if you have the right pitch/diameter prop.
  13. Thread: Honda BF45

    by dark_star
    Replies
    2
    Views
    302

    Re: Honda BF45

    Yup, dumb question:o
    Thank Mike !
  14. Thread: Honda BF45

    by dark_star
    Replies
    2
    Views
    302

    Honda BF45

    what years did honda make the bf45 ?
    would the performance on a low hour motor be similar to a BF50 ?
  15. Replies
    25
    Views
    2,124

    Re: bf50- milky oil

    Thanks for the advice guys
  16. Replies
    25
    Views
    2,124

    Re: bf50- milky oil

    Sorry to pain you all once more, but this is ongoing.
    I spoke with the mechanic and he advised Honda's are notorious for corrosion
    and rather than take a chance at breaking something on an older...
  17. Replies
    4
    Views
    307

    Re: Limited RPM on twin Honda BF60 4Strokes

    I would try dropping to a smaller diameter prop, your dealer should have a variety of different pitches and diameters.
    try an 11x13 and see if that fixes your problem.
    you should get 5800-6000 rpms...
  18. Re: 2000 90hp Honda on lift unstarted for 3 years...what to expect

    If its a carbed model, hopefully the service tech drained the bowls before it was put to bed.
    thats the biggest problem with these , gummed up jets and passages.
    if she's a rough runner after it...
  19. Re: 2000 90hp Honda on lift unstarted for 3 years...what to expect

    I would be inclined to check the oil levels first.
    if all is good, charge up the battery and fire it up.
    from the model year I assume it is fuel injected and not carbureted ?
  20. Re: 08 honda bf25 - cooling indicator port hose

    Take the hose off , it's only secured with a wire spring clip.
    go to your local marine shop and get them to cut you a piece of bulk tube.
    I went with a clear yellow.
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4