Logo

Search:

Type: Posts; User: joe

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. i kinda figgered that..i didn

    i kinda figgered that..i didnt know if it could be from that inline fuel filter or not
  2. " if any of you remember, i wa

    " if any of you remember, i was on this board alot back in the day(last summer) and now my outboard is back..

    1993 C25 25 HP Yamaha tiller

    problem: starts up and runs at idle fine, take it...
  3. Thread: OMC Motor

    by joe
    Replies
    3
    Views
    192

    I just acquired a boat with a

    I just acquired a boat with an OMC stern drive. The motor was advertised as a 1974 OMC GM straight six. The title office says I also need to title the motor. Previous owner did not need title. Is...
  4. Thread: OMC Motor

    by joe
    Replies
    1
    Views
    186

    I just acquired a boat with a

    I just acquired a boat with an OMC stern drive. The motor was advertised as a 1974 OMC GM straight six. The title office says I also need to title the motor. Previous owner did not need title. Is...
  5. Thread: 75 hp Gamefisher

    by joe
    Replies
    9
    Views
    4,292

    " What year is my 7.5 Gamefish

    " What year is my 7.5 Gamefisher? Model number 217-585831 and S/N 9A-247932...


    Thanks,

    Joe "
  6. Replies
    3
    Views
    619

    Mike change your fuel pump. i

    Mike change your fuel pump. i had a 25hp Johnson that did the same thing but since i changed the fuel pump it runs good
  7. Replies
    3
    Views
    9,054

    turn it a couple of times and

    turn it a couple of times and fire it up
  8. Replies
    2
    Views
    315

    CW or LH is standard automoti

    CW or LH is standard automotive rotation
  9. Replies
    3
    Views
    1,929

    Need help. I want to change

    Need help. I want to change the water pump. I unbolted all lower unit bolts. Gently tapped the lower unit and it dropped about 3/4" and then stopped. Where do I disconnect the shift linkage from...
  10. Unplug the stop button wire i

    Unplug the stop button wire if the motor is a rope start model and re-check for spark. Sometimes the stop button corrodes internally and shorts to ground stopping spark.
  11. Replies
    2
    Views
    337

    " I have a 1960 something 9.9

    " I have a 1960 something 9.9 HP. Pulled the lower unit to change the water pump and instead of the copper tube staying put in the head, it came out. Been trying to reinstall it with some silicone...
  12. Replies
    1
    Views
    484

    " Pete, If pumping, it will sp

    " Pete, If pumping, it will spit water from the two upper exhaust relief holes. If your dropping the lower unit might as well change the water pump. You have to disconnect the shift rod. It is...
  13. Replies
    2
    Views
    537

    I have a Johnson 50 around a

    I have a Johnson 50 around a 90's model and I was doing a spring tune-up and found the following. Everything was good untill I went to drain the lower unit oil and water came out. I know that I...
  14. Replies
    2
    Views
    556

    I have a 1979 model 35hp envi

    I have a 1979 model 35hp envinrude that just keeps blowing up power packs ive done went through three i cant figure out the problem ive changed coils and the stater plate and it still does it. Pleas...
  15. Replies
    1
    Views
    453

    1976 25 horspower

    1976 25 horspower
  16. Replies
    1
    Views
    453

    Replaced the head gasket seem

    Replaced the head gasket seemed to help but still
    to hard to start.At idel it runs rough intermiten poping and kills alot tryed new plugs Thanks any help will be apreceated
  17. Thread: Timing mark

    by joe
    Replies
    4
    Views
    396

    could a worn timing chain cau

    could a worn timing chain cause this? - joe
  18. Thread: Timing mark

    by joe
    Replies
    4
    Views
    396

    the type of distributor is th

    the type of distributor is the non HEI marine type with points and condensor.
  19. Thread: Timing mark

    by joe
    Replies
    4
    Views
    396

    I was adjusting the timing on

    I was adjusting the timing on my 83 chevy 350. When i tried to line the mark up (4 deg. btdc) the motor stalled. i was able to turn the distributor to get a fairly constant idle but im having high...
  20. Replies
    0
    Views
    149

    " I have an old 5 1/2 hp Johns

    " I have an old 5 1/2 hp Johnson outboard model CD-11 and need to locate a new starter pull cord and re-coil spring. I live near Romeo, Michigan and need to find a local dealer/parts supplier. Can...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4