Logo

Search:

Type: Posts; User: pvanv

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    9
    Views
    116

    Re: NS40C 361A-1 nissan 40 HP

    The RC box I have is Nissan "silver grey", and is new old stock, in the original Factory box. Originally intended for the 120-140 hp motors, it has electric start (key switch), tilt/trim switch, and...
  2. Replies
    9
    Views
    116

    Re: NS40C 361A-1 nissan 40 HP

    I have an NOS RC box, if that is what you need.
  3. Replies
    9
    Views
    116

    Re: NS40C 361A-1 nissan 40 HP

    This shows the choke solenoid and the main starter switch:
    18232
  4. Replies
    9
    Views
    116

    Re: NS40C 361A-1 nissan 40 HP

    This is how the manual choke connects:
    18231
  5. Replies
    9
    Views
    116

    Re: NS40C 361A-1 nissan 40 HP

    What bit do you want? If RC, that stuff is in the RC box.

    Brown is kill. Ground it and the ignition dies.
  6. Replies
    3
    Views
    55

    Re: Tohatsu M5B 5hp idles but cant throttle.

    Sounds like you need to completely disassemble your carb (including jets and emulsion tube nozzle) AND the float valve), soak overnight in real carb dip (available at any auto parts house), and THEN...
  7. Replies
    9
    Views
    116

    Re: NS40C 361A-1 nissan 40 HP

    Full info is in the Factory owners manual, from nissanmarine.com. If you can't figure that out, ask, and I will help.
    http://www.nissanmarine.com/tech_talk/pdf_files/Nis40C.pdf
  8. Replies
    3
    Views
    55

    Re: Tohatsu M5B 5hp idles but cant throttle.

    What method did you use to clean the carb?
    Here's a pic of the lockout:
    18228
  9. Replies
    2
    Views
    71

    Re: M90a carb fuel inlet barb

    No, the inlet is not available separately. You may be able to cobble up something from an olde tymey NAPA. Look for the store with a guy at the counter who has grey hair (not a catalog-looker-upper),...
  10. Re: Need Lower End /Gear Case for Nissan NS30A2

    Yikes. That's an oldie. IF one for an A4 will fit (dunno), it's over a thousand dollars:


    346Q87301C
    LOWER UNIT 25/30 (NEW STYLE) SHORT
    $1089.35
  11. Replies
    1
    Views
    90

    Re: M70a2 waterpump kit

    353650110m
    liner-no longer available
  12. Replies
    8
    Views
    135

    Re: I want another carb for my MFS5C Tohatsu

    They are identical.
  13. Replies
    8
    Views
    135

    Re: I want another carb for my MFS5C Tohatsu

    I ship worldwide.
  14. Replies
    8
    Views
    135

    Re: I want another carb for my MFS5C Tohatsu

    MihaiP,
    You want:


    3R4032001M
    CARBURETOR ASSY, MFS/NSF6A2
    $122.35
  15. Re: 6HP Tohatsu - drive shaft won't seat correctly after water pump impeller replacement

    You should have started a new thread, as this is a different motor, with a different issue. However, assuming your model is NSF4A2, the problem is likely that you have crud on the driveshaft, and...
  16. Re: Nissan Marine 6 HP Oil on the plug while running

    Assuming you have some kind of 4-stroke (you did not mention your model). Either the oil is over full, or you may have leaky valve guides... or a bad ring.
  17. Replies
    1
    Views
    135

    Re: 5hp Tohatsu stalling in gear

    Year is irrelevant; model is important. I assume you have an MFS5C. The 4/5/6 are identical, except for the carburetor. Idle speed is critical, due to the low moving mass of the small, 1-cylinder...
  18. Replies
    3
    Views
    164

    Re: Nissan NS40C bog down when giving gas

    The P plugs have Projected Tip. They run a little hotter at the tip, and stay cleaner longer. Yours should be OK.
    Whatever idiot told you to leave the jets loose is no one to listen to about carbs.
  19. Replies
    1
    Views
    121

    Re: ECU for TLDI md115a / md115a2

    They are completely different part numbers, so they are not identical. Would it work? perhaps. The A model was made prior to 2010. The A2 has a lot of improvements, including changed ignition curves,...
  20. Replies
    3
    Views
    164

    Re: Nissan NS40C bog down when giving gas

    Yes. There is the idle stop, and the adjustment screw. That's all.

    You did Not clean the carb; you made it shiny. Proper cleaning requires complete disassembly, an overnight soak in carb dip, and...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4