Logo

Search:

Type: Posts; User: faztbullet

Page 1 of 4 1 2 3 4

Search: Search took 0.02 seconds.

  1. Re: Where to find year of Johnson Ocen Pro V6 22HP Outboard

    Has to be 91 up as got the Fastrac trim... been a lottt of lipstick applied to that pig as even hull painted.
  2. Replies
    7
    Views
    37

    Re: Mariner lower unit-final assembly

    The rear thrust bearing will fall out of the groove in carrier and get squished and also cause this problem...pull carrier and inspect.
  3. Re: 2015 and newer etec 40 or 50 . . . common problem points?

    They (BRP) quit making them...no support and parts supply dwindling.Look at other brands..
  4. Replies
    14
    Views
    78

    Re: finding tdc on 2000 70hp jhonson

    That is the correct way to do it..the piston is on the downstroke when you screw in stop, then when continued rotated clockwise the piston will hit stop on up stroke
  5. Replies
    1
    Views
    16

    Re: 2006 115 hp 4 stroke . Gear case

    Call SEI and see if their 205 series will fit...about $1K and 3 year warranty :)...
  6. Replies
    2
    Views
    27

    Re: merc xr6 ignition

    Spark on same side is usually a switchbox issue
  7. Replies
    3
    Views
    40

    Re: 1989 Johnson 175 High temp alarm?

    This would be the first step in troubleshooting...replace impeller
  8. Replies
    3
    Views
    40

    Re: 1989 Johnson 175 High temp alarm?

    When the last time impeller was replaced???
  9. Re: 1986 evinrude 140 v4 vro struggles to get on plane

    Ignition related and check compression as these motors scuff the piston on exhasut side due to bridge port design..
  10. Replies
    10
    Views
    75

    Re: Charging system problem

    Which rectifier you have the square 3 pole or square 5 wire rect/reg????
  11. Replies
    9
    Views
    95

    Re: 1969 Johnson 55hp

    You cant...and if could how would you know how many volts was put out?????
  12. Replies
    7
    Views
    68

    Re: 1979 mercury black max 150hp issues

    That because engine ha no load or backpressure. They will sound and rev up fine on muff if only running on 3 cylinders!!!!
  13. Replies
    10
    Views
    75

    Re: Charging system problem

    What year 115???
  14. Replies
    3
    Views
    30

    Re: cleaning dfi injectorrs?

    I send my customers to Brucato… they send a before and after flow sheet and balancing.
  15. Re: 1996 johnson 115 leaking fuel from air intake on one carburetor. Help!

    No the solenoid problem I refer to is internal..the contacts corrode/wear, this reduces amps to starter..also makes starter/cable to get warm. Then motor wont turn fast enough to make voltage off...
  16. Replies
    10
    Views
    75

    Re: Charging system problem

    You need to only check yellows as they are for battery charging..the other are for ignition system..
  17. Replies
    7
    Views
    57

    Re: 50hp merc efi not idling

    Clean the IAC valve...
  18. Replies
    2
    Views
    40

    Re: 1992 40 Mariner Magnum Limp Mode

    No limp mode on these...you got carb problem
  19. Re: 1996 johnson 115 leaking fuel from air intake on one carburetor. Help!

    Remove spark plugs and retest..if good spark battery, cables or solenoid problem
  20. Replies
    2
    Views
    44

    Re: 1992 40 Mariner Magnum Gear Ratio?

    1.83:1
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4