" I want my motor back Greg, I coming to get it boy! "

I am trying to find some information on the rpm range of the Perkins 4-108 diesel engine. I have read/heard that if you run the engine at 1800 rpms you get more longivity and less headaches than if...

" I have a 79 evinrude 115hp that was completly rebuilt in 98 its bored 30 over I want to do a comp test on it need to know what it should be . presently redoing carbs it also had lower unit redone....

" I have a 79 evinrude 115hp that was completly rebuilt in 98 its bored 30 over I want to do a comp test on it need to know what it should be . presently redoing carbs it also had lower unit redone....

" I have a 1986 Johnson 225 VRO. Vro has been disconnected and converted to premix. Engine runs great, however on the last trip out Tachometer needle fluttered and quit registering and also...

" I replaced the lower unit and water pump is working, however water does not reach the heads resulting in overheating. I am also looking to find a schematic of this motor if any one has one or can...

" johson 5.5 seahorse ser# 7518 53219 need to identify,want to restore. "

Anyone have a place to get a rebuilt OMC 800 series sterndrive? I live on the West coast.

I just became the owner of a 1959 25' Owens Flagship. It needs somewhat extensive restoration and I am having a very hard time finding any info on this year of owens. any links you would like to...

I have recently overhauled the above engine. I am running a 19 prop. The engine will normally only rev to 4500rpm. I recently stored the engine for the winter and noticed an immediate improvement in...

" I just bought this boat and the first time I took it out on the water it would only get up to 2500 rpm. Checked fuel pump and filter and it looked fine. Checked compression and found them to be 120...

Thanks for taking the time to share that valuable information with me. May you be richly blessed...

David

" I just bought this motor and put it on a test tank to see how well it runs. The motor starts right up with the choke engaged. However, I am unable to push the choke back in without the motor...

" Hello,I am looking at 2 used 302 egines to puchase.One of the engines is counter rotating. My question is can a counter rotator by switched back to a standard rotation.The people I have talked to...

Can anybody tell me the correct conversion to Fram or some other easily available filter for the Crusader 270hp/350ci motor? The crusader part is 22679. Thanks

" I am considering using a 77 merc 150 outboard to power a 16ft speed boat (glastron)closed bow shallow hull.Were these motors good,ok,bad etc.It looks like it will need an engine wiring harness as...

I've got a 3.5 hp that says Foremost (JC Penny) ont the cowl. Someone told me it was made by Chrysler. I don't see any markings on the motor.
Does anyone have info on it? (It was found at the...

To what negative consequances could lead the crankcase high pressure in the industrial diesel engines?

To what negative consequances could lead the crankcase high pressure in the industrial diesel engines?

To what negative consequances could lead the crankcase high pressure in the industrial diesel engines?