Logo

Search:

Type: Posts; User: Bt Doctur

Page 1 of 4 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    8
    Views
    93

    Re: 454 upgrades, worth it?

    Up the HP if your 24 foot or less , use a soft right hand or install a Bravo
  2. Re: Smoke in idle and self-ignition when turned off 2008 / 4.3 TKS

    Install a standard carb with a standard electric choke
  3. Replies
    1
    Views
    107

    Re: trim sending unit corroded

    ebay $50
  4. Replies
    1
    Views
    82

    Re: Bravo one 502 starter replacement.

    Try a thin wall 6 point ,with a 3 inch extention . tap with hammer to seat the socket
  5. Replies
    13
    Views
    170

    Re: Ford 302 - Possibly Wrong Rotation

    click to enlarge
    https://i.ibb.co/q72g9R8/Untitledvd.jpg
  6. Replies
    13
    Views
    170

    Re: Ford 302 - Possibly Wrong Rotation

    Ford has been out of the marine field and most parts are no longer made. If the transmission is still in the boat rotation can be verified by just looking at the front of the pump. If the trans has...
  7. Replies
    6
    Views
    182

    Re: Brand new 5.7L Volvo Penta idle issue

    get a hand held laser temp gun and compare the reading at the sender to the gun. Some can be off as much as 15 degrees on either side .
  8. Re: 1973 888 mercruiser water seperator fuel filter vent hose routing?

    if this is a Ford motor and uses the glass bowl attached to the fuel pump then that is a hose to tell you if the diaphram has ruptured and needs to go to the carb
  9. Replies
    22
    Views
    251

    Re: Keeping it cool

    Vick, best to start your own post but unless its a volvo I would say not possible
  10. Replies
    11
    Views
    205

    Re: Winterize 5.7L MPI Raw Water cooled

    Mine is a closed system ( only elbows have raw water )

    almost right, the HX has a drain too
    Typically on a MPI with manual drains. 1 on each side of the block , 1 on each manifold , 1 in the cool...
  11. Replies
    11
    Views
    205

    Re: Winterize 5.7L MPI Raw Water cooled

    After getting to operating temp, removing the thermostat, reinstalling housing, less the thermostat, run engine while running antifreeze through his drive until pink shows at exhaust - will that...
  12. Replies
    8
    Views
    146

    Re: Omc tilt issues

    I actually had to machine up a new cap for one of those units
  13. Replies
    22
    Views
    251

    Re: Keeping it cool

    So just where did you manage to install the sensor that dosent have wet exaust running thru it?
  14. Replies
    22
    Views
    251

    Re: Keeping it cool

    160 is the one you need, never a 180 even with FWC
  15. Replies
    21
    Views
    253

    Re: Merc 305 to Volvo 350 swap

    remove the drive BEFORE removing the motor. ask how if your not sure how
  16. Replies
    8
    Views
    146

    Re: Omc tilt issues

    click once or twice to enlarge
    https://i.ibb.co/3R7D62F/Untitledvt.jpg
  17. Replies
    8
    Views
    146

    Re: Omc tilt issues

    http://www.boatservicehaarlem.nl/omc_tilt_system_b.pdf
  18. Replies
    8
    Views
    146

    Re: Omc tilt issues

    you really dont want to do that . find a manual first.. may be the impulse coupling you hear
    Remove the retaining bolts, the snap ring, cap should come out. If not you have to pull the motor drive...
  19. Re: Aloha all...need a transom template for a VP 275 sterndrive

    click twice to enlarge
    https://i.ibb.co/wBHc0D2/Untitledvo.jpg
  20. Re: Aloha all...need a transom template for a VP 275 sterndrive

    using the pic supplied draw a vertical center line , each hole fron the centerline is
    top set 100mm, 3 15/15, 3.93 inches
    next set 190mm. 7 15/32, 7.48 inches
    middle set 216mm, 8 1/2, 8.50...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4