Logo

Search:

Type: Posts; User: phillnjack

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    266

    Re: quaestion for joe reeves

    2 all the 1995 60hp and 70hp are identical apart from the carbs. as far as I a aware ???

    3 ahh yes, i didn't think about the electrical part being a problem, i see what you mean though so I will...
  2. Replies
    3
    Views
    266

    quaestion for joe reeves

    Hello mr reeves
    is there a way I can use the sensor that was in the vro system as a low fuel warning ?
    I have a 1995 triple evinrude 60/70 hp and have the vro completely disconnected etc.
    no oil...
  3. Re: 91 evinrude 60hp VRO head gasket problems

    do what racer says and get the head nice and level, or take the head to machine shop and get it skimmed.
    I know what you mean about cost of shipping etc as i am in the uk too.
    get the head skimmed...
  4. Replies
    2
    Views
    200

    Re: 1994 Johnson 90hp issue

    +1 on the above...
  5. Replies
    3
    Views
    1,276

    Re: Disconnect oil injection

    disconnect the vro and play safe..
    its dead easy.. dont bother cutting the oil pipe at engine end, just undo the pipe inside the cowling and plug it. then disconnect the wire plugs like joe says....
  6. Replies
    19
    Views
    2,279

    Re: Johnson powerpack/coil wiring

    sounds to me like your being messed around big time by the place who sold you the power pack.

    you can unpick the connectors from the rubber bock if nice and careful, then put them in the correct...
  7. Replies
    6
    Views
    240

    Re: Spark plug question

    I was going by what omc/brp has listed as the correct plug, but FAZTBULLET & BOOBIE are correct...

    Just read somewhere else that Bill ghor wrote that omc did change from the 78's to the 82, but...
  8. Replies
    1
    Views
    8,790

    Re: need help... vro not pumping at all.

    rotten diaphragm in the fuel pump...expensive..

    jus get old style fuel pumps an pre-mx, save a fortune on un-reliable vro..
  9. Replies
    2
    Views
    139

    Re: General head gasket question

    you need a new compression gauge as no way will that run with 70 psi compression...

    and grey sludge is normally water sign, it could be in the tank , only needs small amount in the bottom of the...
  10. Replies
    3
    Views
    173

    Re: OMC control box question. HELP!

    sounds like you have a bad control box, yes there is something your supposed to press in to get it out of nutral, but what is this about ball bearing ?
    dont you have a lever to squeeze ?

    post a...
  11. Replies
    4
    Views
    371

    Re: 1995 Johnson VRO system

    the 1995 vro is terrible, ive got 2 of them if you want to come and collect them, I would never use vro its total crap.
    go back to old style the more reliable and far more consistent to the motor...
  12. Replies
    24
    Views
    859

    Re: Bombardier GT how many hp ?

    look behind carburettor first, sometimes it is just a thin plate to remove. sometimes bigger carburettor.
    sometimes bigger jets in carburettor.
    need number from carburettor to see if it is same...
  13. Replies
    10
    Views
    586

    Re: 1990 88 SPL Carb Draining

    I think if I was you I would potter around close to the shore for atleast an hour trying it at different speeds. you should be fine now, but this is
    maybe me to think about a little kicker motor on...
  14. Thread: at idel

    by phillnjack
    Replies
    10
    Views
    279

    Re: at idel

    clean and gap plug then check for spark jumping the full 7/16th gap.
    what is the rpm at your idle when this happens ?
  15. Replies
    19
    Views
    919

    Re: 50HP Johnson Slowly dropping in water

    I think you need to replace the seals that you have not touched.
    did you replace any of the seals/ o-rings on the relief side ?
  16. Replies
    11
    Views
    781

    Re: 1990 70 HP Evinrude VRO Problem

    have you thought about cleaning the filter in the oil tank ? and what about the tiny little skinny oil filter under the hood ?
    have you cleaned oil out of oil tank and filtered it to make sure it...
  17. Replies
    2
    Views
    3,905

    Re: How to adjust VRO Oil flow rate?

    there is no adjustment on the vro, it either works good or goes bad.
    it cost a fortune for a new one, and nobody repairs them, they are total crap.

    get a new but old style fuel pump, you wont...
  18. Replies
    10
    Views
    634

    Re: No Spark... sometimes..

    what is the model number of this engine ?
    because a 1983 dont have the S.L.O.W mode on the electrics.
    1983 makes it a 49 cu in motor no the later 56 cu in. from 1986 onwards.....
    if you made a...
  19. Replies
    10
    Views
    586

    Re: 1990 88 SPL Carb Draining

    That is realy bad fuel contamination.
    I think I would drain the tank completely and put that down to a bad experience.
    Dont take any chances with bad fuel, its good you have caught the problem now...
  20. Replies
    24
    Views
    859

    Re: Bombardier GT how many hp ?

    ok I shall explain why.
    when you insure a boat and engine , sometimes the boat might only be allowed 10hp maximum on transom !!!
    this way you can have this size engine that is 10hp max at say...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4