Logo

Search:

Type: Posts; User: vlotta

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    176

    Re: UFP DB-42 Caliper Question

    I complete understand about not spending to much time but again like I said I don't have the option to order. Already called UFP being that they are only 20 minutes from me and they will not...
  2. Replies
    3
    Views
    176

    UFP DB-42 Caliper Question

    Does anyone know what the DB-42 caliper crosses over to in automotive. I have a hard time believing they manufactured a new caliper from scratch. My issue is I'm trying to get the piston to rebuild...
  3. Re: Something doesn't look right with my outdrive

    is there a reason for this space? Won't water get into the drive bellow area?
  4. Something doesn't look right with my outdrive

    Maybe I have never payed close attention to my outdrive but after replacing my gimbal bearing I notice there is a gap at the top. I don't know if i'm missing a gasket but I searched the diagram of my...
  5. Replies
    7
    Views
    263

    Re: Engine alignment tool question

    I used a Gimbal bearing installer. 21473

    The seal is seated all the way in and then the bearing is seated all the way in but being that my bearing doesn't have a flat side (others have said the...
  6. Replies
    7
    Views
    263

    Re: Engine alignment tool question

    Thank you for the help, can you give me your opinion on another situation. I was wondering if I installed the bearing to far. I installed it until it bottomed out but now it is hard to spin by hand...
  7. Trailer brakes dragging only when hooked up to truck....Please help

    My old breaking system would only operate under heavy breaking so I rebuilt it. Now they seem to over work. With the trailer unhooked and the tires jacked up each one spins freely when applying...
  8. Replies
    7
    Views
    263

    Engine alignment tool question

    When aligning your engine should the alignment tool go all the way into the coupler? My tool only goes in the first two inches due to the size of the second stage of the tool. I could not locate a...
  9. Replies
    1
    Views
    268

    Engine alignment tool question

    When aligning your engine should the alignment tool go all the way into the coupler? My tool only goes in the first two inches due to the size of the second stage of the tool. I could not locate a...
  10. Re: Grinding noise when drive is turned to the left or right

    After reading several post on this website I see you are very knowledgeable and helpful. Thank you for that it really helps those of us that have mechanical abilities but just need some guidance....
  11. Re: Grinding noise when drive is turned to the left or right

    Ok last question. I just like to have all my ducks in a row before pulling the drive. I read on another thread that the DP-SM drive shaft is a non serviceable drive and I would have to buy the whole...
  12. Re: Grinding noise when drive is turned to the left or right

    Thank you for the info Rick. Is there a way to diagnose the issue to determine which one it is or do I need to pull the drive and physically inspect the bearings?
  13. Grinding noise when drive is turned to the left or right

    I was doing my preseason maintenance and when I started the boat I heard a loud grinding noise. I happened to notice that when I turned the prop to the center it went away. Only makes the noise when...
Results 1 to 13 of 13