Logo

Search:

Type: Posts; User: flyingscott

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Thread: New Gears

    by flyingscott
    Replies
    2
    Views
    29

    Re: New Gears

    There is a special tool for that. Find a dealer in your area and have them shim it for you.
  2. Replies
    6
    Views
    55

    Re: Neutral switch

    Look for the paperclip and then you can attach it.
  3. Replies
    6
    Views
    55

    Re: Neutral switch

    Is this a tiller or a remote model? If it is a tiller is it a side shift or tiller shift? Maybe put up a pic of where it is?
  4. Replies
    6
    Views
    55

    Re: Neutral switch

    What is the serial # of the motor. Does he have the old switch yet? Was there a Bracket on the old part?
  5. Replies
    3
    Views
    37

    Re: 1985 Merc 25hp tiller

    Can you get a pic of the tiller from the side of the tiller maybe just the rubber handle.
  6. Re: 1999 Evinrude 8HP Tiller Remote Throttle Control

    Is this a suzuki built motor?
  7. Re: johnson 120 VRO 88, Idle issue? Running Rich? Stalling

    Sounds like it is flooded with water. A flooded motor will spit blue or black smoke out not white.
  8. Re: 1990 Mag 2 150hp motor losing speed/surging RPM's

    I don't think those have compression that high. Your compression sounds good I could be wrong but I am pretty sure your compression is fine. Check for a broken motor mount.
  9. Replies
    25
    Views
    815

    Re: 1974 Johnson Stinger 2

    still 3 yrs old. Can people read anymore
  10. Replies
    3
    Views
    37

    Re: 1985 Merc 25hp tiller

    Yes you can put controls on that motor. I would find a parts motor to do the conversion. Your tiller handle has a throttle lock on it i believe to hold a steady speed. Put a pic up of the tiller.
  11. Re: 2000 Johnson 70HP VRO/OMS issues - Convert to standard fuel pump?

    Somebody pulled the fuel line off to try and run the carbs empty? Air leak on the fuel side of the pump?
  12. Re: 25hp Johnson 2 stroke ra for few min started sounding diff n then shut down n steam n smoke hiss

    Get a different gauge and try the test again. 90 is not good.
  13. Re: 25hp Johnson 2 stroke ra for few min started sounding diff n then shut down n steam n smoke hiss

    Do a compression test.
  14. Re: 73 evinrude 135 possible jetting issue?

    You do not have a VRO pump about 10 yrs to early for that. Just have somebody pump the primer ball while you are accelerating. If that makes it better you probably have a fuel pump issue. Has this...
  15. Replies
    1
    Views
    44

    Re: Idling issue

    Soak and clean and rebuild your carb.
  16. Replies
    7
    Views
    70

    Re: Intermittent power on 15hp 2-stroke

    Does the spark plug get shiny clean? Do a compression test.
  17. Replies
    7
    Views
    70

    Re: Intermittent power on 15hp 2-stroke

    If pumping the ball makes a difference it is the fuel pump. So do you have a long shaft on a short shaft boat or vice versa. Put up a pic of the bot and motor from the side. Have you tried a...
  18. Replies
    7
    Views
    70

    Re: Intermittent power on 15hp 2-stroke

    Try pumping the primer ball when that happens. If that makes no difference take the carb off and clean it. Or are you running a long shaft motor on a short shaft boat?
  19. Replies
    4
    Views
    78

    Re: 1997 yamaha outboard 90 2 stroke

    Why are you premixing?
  20. Re: 1995 130hp evinrude surging and cutting out

    Have you tried pumping the primer ball when that is happening? Is the VRO still connected? Have you tested all the components when they are warm?
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4