Logo

Search:

Type: Posts; User: bondo

Page 1 of 4 1 2 3 4

Search: Search took 0.04 seconds; generated 35 minute(s) ago.

  1. Thread: Leak issue help

    by bondo
    Replies
    8
    Views
    72

    Re: Leak issue help

    Ayuh,..... All of that, 'n a new lower shift cable,.....

    How old is the hull,..?? the transom could also be rotten, causin' the leak,....
  2. Re: Could water ears flood a mercruiser v8 if engine not running ?

    Well,..... Atleast it's Readable,.......
  3. Re: how to choose the correct prop. for optimum speed

    Ayuh,..... If the motor can't make the recommended rpms at Wot, it's lugging,.....

    It's lugging All the time,..... at All rpm levels,....

    Luggin' the motor causes excess cylinder heat, 'n...
  4. Replies
    5
    Views
    54

    Re: 19692T01 Pulley Removal

    Ayuh,..... Put the belt back on,...... Tight,.....
  5. Re: Could water ears flood a mercruiser v8 if engine not running ?

    HOLEY MOLEY,..... Have you ever heard of a Paragraph,..??..??

    It ain't how much yer sayin', it the lack of paragraphs that make yer posts, Unreadable,.....
  6. Thread: 3.7 to 5.7

    by bondo
    Replies
    5
    Views
    45

    Re: 3.7 to 5.7

    Ayuh,...... A fully dressed 5.7l is atad over 500 lbs,.....

    You'll need a matchin' drive too,..... the gear ratios are very different,.....
  7. Re: how to choose the correct prop. for optimum speed

    Ayuh,...... Only if you wanta burn holes in the piston tops,.....
  8. Replies
    5
    Views
    54

    Re: 19692T01 Pulley Removal

    Ayuh,..... Take the 4 bolts out, give it a few taps, 'n it oughta pretty much, fall off,......
  9. Thread: Leak issue help

    by bondo
    Replies
    8
    Views
    72

    Re: Leak issue help

    Ayuh,.... Tiltin' the drive shouldn't make any difference, at all,......

    My guess is the drive bellows is holed,....
  10. Re: mercruiser 5.0 had hole in oil pan fixed and refilled and now loud clanking and power loss HELP

    Ayuh,..... So what caused the hole,..??

    If ya ran it outa oil, I'm guessin' the bearings are junk, along with the crankshaft,......
  11. Re: Shift Intercept switch location on 1974 Mark Twain with 165 Mercruiser

    Ayuh,..... Look on the top of the transom inner plate, above the rear motor mounts,.....
  12. Replies
    4
    Views
    48

    Re: 1990 bass tracker tournament tx

    Ayuh,..... With resin, 'n cloth,..... Like boats are fiberglassed,.....
  13. Replies
    3
    Views
    82

    Re: 1979 seaswirl OMC 140 sterndrive

    Ayuh,..... There's only one way to find out,....... Ya gotta Look,.....
  14. Re: Could water ears flood a mercruiser v8 if engine not running ?

    Nope,..... Not if everything is in workin' order,.....
  15. Replies
    4
    Views
    48

    Re: 1990 bass tracker tournament tx

    Ayuh,.... Plywood is 4' wide, piece it together, 'n glass it into a single deck,.....
  16. Re: GM 5.7L , SB350ci DISTRIBUTOR CONVERSION INFO NEEDED

    Ayuh,..... The Delco Voyager is a reasonably priced, fine ignition swap too,....
  17. Replies
    2
    Views
    51

    Re: Blue Smoke After Season Startup

    Ayuh,..... Run it, 'n see if it uses any oil,......

    Check the spark plugs, 'n see if one is more fouled than the rest,.....

    Motors wear out,.... Could be rings, or valve guides,...
  18. Replies
    15
    Views
    152

    Re: RPM limits for operating -4.3 Alpha 1, Gen 1

    Ayuh,..... Yer motor doesn't have a rev-limiter,.... it's to old for that, rev-limiters are only seen on the newer Mpi/ Efi motors,...
  19. Replies
    6
    Views
    78

    Re: Replace Engine Coupler

    Ayuh,.... That proves Nothing,..... The hub can be blown, but still turn by hand,.....

    'n, Yes, the motor Has to come out to change the coupler,.....
  20. Re: Could water ears flood a mercruiser v8 if engine not running ?

    Ayuh,..... If you want any answers,..... Learn to use paragraphs,......

    No way in f*^kin' 'ell, I'm gonna wade through that word soup,......
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4