Logo

Search:

Type: Posts; User: bondo

Page 1 of 4 1 2 3 4

Search: Search took 0.04 seconds.

  1. Re: Windshield pass through door striking frame - how to adjust?

    Ayuh,...... Odds are the dash is sinkin' into the hull,.......

    Lift on both sides by the walk-thru, 'n I bet the window closes perfectly,.....
  2. Replies
    3
    Views
    80

    Re: How far gone, is too far gone?

    Nope,......
  3. Replies
    3
    Views
    86

    Re: Mercruiser 5.7 Acceleration Issue

    Ayuh,...... Sounds like it's runnin' lean,.....
  4. Replies
    3
    Views
    87

    Re: 5.7 Mercruiser I/O Trim issues

    Ayuh,..... See if it'll run up, 'n down with the cap off,.....
  5. Replies
    2
    Views
    65

    Re: 1992 Mercruiser 4.3 block discontinued

    Ayuh,..... Update to a '96 or newer to get the vortec heads,..... those heads are worth 20/ 25 hp,....

    You'll need a newer intake manifold, 'n have to add an electric fuel pump,.....

    Yer...
  6. Replies
    4
    Views
    222

    Re: Wiring harness plug diagram

    Ayuh,...... I believe you find they're all on the ignition circuit, Ya,.....
  7. Re: Boat Bogging and voltage going crazy at high RPM?

    Ayuh,..... Follow the battery's ground wire to the other end,.....

    Should be a ground stud on either side of the flywheel cover at it's block intersection point,.....
  8. Replies
    5
    Views
    112

    Re: Engine block differences

    Ayuh,..... Is the hull worth the investment of the time, 'n money,.....

    If yer in love with the hull, Up-date yer motor to a recent production 4.3l Vortec,......

    You can pick up a pile of...
  9. Re: Help Please - 2007 Mercruiser 4.3L AlphaOne Engine Hesitation

    Ayuh,...... Examine the Contents of the filter, for any clues,.....
  10. Replies
    3
    Views
    116

    Re: 1992 Glastron Fuel Sender

    Ayuh,..... Follow it's wires, 'n cut a new access hole,....
  11. Replies
    4
    Views
    222

    Re: Wiring harness plug diagram

    Ayuh,.... Skip the plug, 'n just jumper power to the coil's (+) terminal,.....
  12. Thread: Carb replacement

    by bondo
    Replies
    1
    Views
    94

    Re: Carb replacement

    Ayuh,..... The Edlebrock 1409 is based on the Carter AFB, 'n should be an easy swap,.....
  13. Thread: Need help

    by bondo
    Replies
    5
    Views
    117

    Re: Need help

    Ayuh,..... Check for voltage at the coil's (+) terminal, with the key On,.....
  14. Replies
    11
    Views
    235

    Re: 2003 mercruiser 5.0 with bravo 3 outdrive

    Ayuh,..... Loose, broken, or corroded wirin' in the ignition,..??..??
  15. Replies
    3
    Views
    116

    Re: 1992 Glastron Fuel Sender

    Ayuh,..... On the top of the fuel tank,................................. somewhere,....
  16. Replies
    15
    Views
    266

    Re: 4.3L Mercruiser bogging down issue

    Ayuh,..... It's still starvin' for gas,......

    Look, 'n see if the shift interrupt switch is still hooked up,.... If unhooked, it won't come outa gear,.....
  17. Re: Mercruser engine swap with 1988 3.0 Chevy motor

    Ayuh,..... The long blocks should be the same,.....

    The fully dressed motors are very different though,....
  18. Replies
    1
    Views
    75

    Re: Charging Question

    Ayuh,..... It'll do that on start up,..... but once ya rev it, it should show 13/ 14 volts, even at idle,.....
  19. Thread: Grease!!!

    by bondo
    Replies
    14
    Views
    214

    Re: Grease!!!

    Ayuh,..... Read my tagline,..... The u-joints don't care,.....
  20. Replies
    2
    Views
    116

    Re: Mating a 87+ 260 to a 85 sterndrive

    Ayuh,..... Sierra does make such a coupler, 'n that's probably the number,.....

    Ya just need a Chevy flywheel, for a standard transmission,..... Nothin' "Marine" 'bout it,....
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4