Logo

Search:

Type: Posts; User: racerone

Page 1 of 4 1 2 3 4

Search: Search took 0.07 seconds.

  1. Re: 1986 johnson gt 150 will crank but not stay running

    Compression test shows what ?----Post your numbers.
  2. Replies
    7
    Views
    54

    Re: 1989 Evinrude 100xp Power Head Removal

    I did this method 30 years ago and now I can't remember exactly either !
  3. Re: 75hp Johnson bogs down in river but not land

    A dynamometer puts a " load " on the engine when on dry land.
  4. Replies
    4
    Views
    43

    Re: Pull cord locked up

    The 96 models have a recoil above the flywheel.-----Locked by a rod that connects to shift linkage.-----In gear you can not pull the cord.----If you can not pull in nuetral repairs /adjustment to...
  5. Thread: Will not run

    by racerone
    Replies
    15
    Views
    288

    Re: Will not run

    Key is to be pushed in while cranking it over !!
  6. Re: 75hp Johnson bogs down in river but not land

    Even in gear on a hose it is still neutral.-----The prop does no work spinning in air !!!
  7. Replies
    2
    Views
    26

    Re: 1980 Johnson 85hp stuck throttle

    You do NOT have a choke lever on the control box.------Motor is choked / primed by pushing in the key WHILE CRANKING I think.
  8. Replies
    7
    Views
    54

    Re: 1989 Evinrude 100xp Power Head Removal

    Use a 5/16" drill and drill from the side.------Near the top to cut the bolt.-------Those long bolts should have been given a drain hole at the factory to drain water out.------Just another oversight...
  9. Re: 1980 Johnson 35 HP 2-stroke - problem with gears

    This bit about the driveshaft needing to be aligned at the pinion is total nonsense.
  10. Re: 1956 Evinrude 10 hp Will not stay running HELP!!

    It is not getting fuel.------Check pick-up in the tank.-----Cap on tank must be tight.
  11. Replies
    5
    Views
    132

    Re: 15 HP- Adustment for Recoil Lockout.

    It may require bending the rod to suit so that it can be pulled in neutral every time.
  12. Replies
    7
    Views
    82

    Re: 50hp electric shift, yellow plug

    Correct 71 / 72 model 50 hp and the 72 model 65 hp used the yellow plug.----So not easy to find.-----If you understand wiring and volts you can make up a system to work.----I am not going to give the...
  13. Re: '96 Evinrude 150 OceanPro - Starting issues

    That solenoid was used from 1980 to 2007 and is very good and reliable.
  14. Re: '96 Evinrude 150 OceanPro - Starting issues

    The o-ring may need to be replaced on red lever.------Are you pushing the key in while cranking it over , yes or no?----Have you tested to see if the primer valve opens when you push in the key...
  15. Replies
    8
    Views
    159

    Re: Johnson 1962 RK25D 40HP, no spark

    Gap for the points is 0.020"-------Better yet use the method that uses timing marks on flywheel and magneto plate.-----I have been trolling with a 1963 model 10 hp with the same magneto...
  16. Replies
    5
    Views
    87

    Re: 1989 40 hp evenrude vro e40 tlcec

    The part in the back is called a bearing housing and when installed it does NOT rotate.------Used gear housings can be found if you look.-------But you have to inspect all internal bits first as they...
  17. Replies
    5
    Views
    87

    Re: 1989 40 hp evenrude vro e40 tlcec

    Those retainers are located to put reverse gear in an exact location.----You need to take it all apart to inspect all parts for rust damage.----If all is well find a good used case to make this...
  18. Replies
    6
    Views
    129

    Re: Problem timing E70TLEOR

    If the key is sheared the timing on the flywheel ( when using a timing light ) does not change.
  19. Re: Opinions on Sierra Full Synthetic 2 Cycle TC-W3 Marine Engine Oil?

    Oil discussions are always lively and can be very good entertainment.
  20. Re: Opinions on Sierra Full Synthetic 2 Cycle TC-W3 Marine Engine Oil?

    Rooky66-----Was TCW-3 oil available in 1966 ??----Maybe it was NOT Available and therefor not mentioned on the label of your 1966 motor !!
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4