Logo

Search:

Type: Posts; User: makomark

Page 1 of 4 1 2 3 4

Search: Search took 0.05 seconds.

  1. Re: Best Time, Place, Way to Buy a New Outboard

    Find a dealer with a decent reputation....they are typically responsible for installation and setup of your engine....and they are key to a 'success'....
  2. Re: Wiring Access from Console to Bow on 1993 Bass Tracker Pro V 17

    My buddy has that riveted hull...when we rewired his, we just chased the new wires where the old ones went up front...following the NAV light and the remote TRIM wires...not hard..just tedious....
  3. Replies
    6
    Views
    171

    Re: Electronic advance

    I'd say its more of a by-product of aftermarket vs OEM....with the exception of the marine use, the other applications using that distributor use an ECM-controlled timing scheme. I'd bet many...
  4. Replies
    7
    Views
    4,966

    Re: Graymarine Model 135

    check over at oldmarineengine.com...they Gray knowledge base is really over there....around here, I'd say we do well with everything newer than the mid 60's....
  5. Re: 1997 Mercruiser 5.7L carburator throttle plate issue

    longer isn't better...I'd suggest replacement to match what was there regarding materials.

    The screws are typically staked .... locktite should be ok if you properly prep the shaft and screws and...
  6. Replies
    3
    Views
    249

    Re: Gas Gauge Pegged

    "pegged past empty" suggests an open sensor lead....
  7. Re: Mercruiser Alpha one Gen one upper half bearing play

    And make sure the new bearings get shimmed properly....
  8. Replies
    2
    Views
    76

    Re: 270 Heat Exchanger Advice

    The remnants of the pencil should be just inside the cap....

    Its best practice to use new gaskets whenever the caps are pulled for servicing...its your choice to reuse what you have...if it works,...
  9. Re: help with right hand left hand motors rotation.

    Here's the way engine rotations are described....look at the flywheel...if it spins clockwise, its a RH engine, if it spins CCW, its LH. the LH rotation is 'standard'.

    on the BW inline reduction...
  10. Replies
    4
    Views
    145

    Re: mercury the worst purchase I ever made!

    2X...real crappy....with a few integrity issues, too.

    And then there's the whole concern about the break-in procedure.....but that's a context switch...
  11. Re: Finally - pulling the old 454's out on Friday

    I'd be more inclined to use something solid - 6x6's should be stable enough...should make the yard owner a little bit happier as well.

    I'd also have a few 1x4 (or 2x4) pieces just in case ... and...
  12. Replies
    8
    Views
    98

    Re: Merc 3.0 Won't Turn Over

    My thought was the neutral switch wasn't closed...so move the shift lever around and then back to the detent...

    could also be time to clean up the main harness connector (engine harness to helm...
  13. Replies
    8
    Views
    98

    Re: Merc 3.0 Won't Turn Over

    reseat the shift lever to neutral...
  14. Replies
    3
    Views
    86

    Re: Fuel pump issues

    After a bit of pondering, I think there is also a fuel pump relay...they are known to have finite service lives as well...
  15. Replies
    3
    Views
    86

    Re: Fuel pump issues

    they have the electric fuel pumps, right?

    if so, it could be the pump is dying or the infamous oil pressure safety switch is on the way out. best way to figure it out is to monitor the +12VDC wire...
  16. Replies
    4
    Views
    154

    Re: Water on spark plug

    specifics depend upon the cooling configuration of the engine...

    typically, you want the one-hole gaskets where the raw water flows - their use is to ensure the water passages are (mostly) full to...
  17. Re: Crank but no start after running well all day - no fuel from injectors - 2000 5.7l EFI

    thanks for closing the loop...
  18. Replies
    5
    Views
    107

    Re: Compression Test HELP

    without knowing any further details, here's one opinion....

    The test results show the engine is serviceable, per GMs current recommendations regarding compression tests.

    I'd throw the BS flag...
  19. Replies
    33
    Views
    283

    Re: HELP MAYDAY TOTALY GREEN Scallywag !

    That's not one of the adjectives I'd use....even without the duct tape....

    The cylinder looking thing is the connector that joins the harness going to the instrument panel to the engine...
  20. Replies
    4
    Views
    114

    Re: Log style riser gaskets

    Never seen what you described...the gasket needs to 'give' some in order to seal the surfaces its sandwiched between...otherwise, it won't do very well...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4